Question is ⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to, Options are ⇒ (A) only holes, (B) only electrons, (C) mainly holes, (D) mainly electrons, (E) , Leave your comments or Download question paper.

Question is ⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to, Options are ⇒ (A) only holes, (B) only electrons, (C) mainly holes, (D) mainly electrons, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a p-n-p transistor is operating in active region, the current in the n region is due to
A.	only holes [Wrong Answer]
B.	only electrons [Wrong Answer]
C.	mainly holes [Correct Answer]
D.	mainly electrons [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Magnetic susceptibility of copper is -0.5 x 10^-5.

Reason (R): Copper is diamagnetic material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of select lines in ALU 1C 74181 is
2
4
8
16

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna

⇒ Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be
4 mW
1 mW
7 mW
1/4 mW

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ Consider the following statement in FORTRAN 77 2 values could be read and stored asX (0), Y (0)
4 values could be read and stored asX (0), Y (0), X (2), Y (2)
6 values could be read and stored as X (0), Y (0), Y (2), X (3), Y (3)
none of the above

⇒

Assertion (A): The expression E = - ΔV, where E is the electric field and V is the potential is not valid for time varying fields.

Reason (R): The curl of a gradient is identically zero.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒ In molecules of ionic crystals, orientation polarization is zero.
TRUE
FALSE

⇒ The sum S of A and B in a Half Adder can be implemented by using K NAND gates. The value of K is
3
4
5
none of these

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ Which of the following is high frequency transmission line?
An impedance transformer
Frequency compensator
Flying resistor
None of the above

⇒ Spot the odd one out
aluminium
silver
porcelain
copper

⇒ In 8085 microprocessor, what are the contents of register SP, after the interrupt has been star
0210 H
0211 H
054 CH
054 EH

⇒ To bypass a 100 ohm emitter resistor at
10 μF
100 μF
1000 μF
1 μF

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ The F.T. of a conjugate symmetric function is always
imaginary
real
conjugate Unsymmetric
conjugate symmetric

⇒ RMS value of i(t) = 10[1 + sin (- t)] is
10
10/2
l50
102

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ When performing numerical calculations in floating point arithmetic

Error may occur due to finite representation of numbers.
Error may occur due to rounding.
Error may occur due to finite representation of inherently infinite process.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The modulation index of an FM is changed from 0 to 1. How does the transmitted power change?
Gets halved
Gets doubled
Gets increased by 50 percent
Remains unchanged

⇒ An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is
1
0.8
0.6
0.4

⇒ The ripple factor of power supply is a measure of
its filter efficiency
diode rating
its voltage regulation
purity of power output

⇒ In Quine-Mclusky method of Boolean function reduction; __________ , are treated as __________ and therefore discrepancies may occur in the final solution, therefore this method is not applicable to the functions with __________ .
zeros, don't care conditions, zeros
one's, don't care conditions, one's
don't care conditions, zeros, don't care conditions
don't care conditions, don't care conditions, don't care conditions

⇒ If A is 1011, A" is
1011
100
1100
1010