Question is ⇒ When a p-n Junction is forward biased, Options are ⇒ (A) the current flow is due to electrons only, (B) the majority carriers in both p and n materials are driven toward the junction., (C) the majority carriers in both p and n materials are away from the junction., (D) both (a) and (c)., (E) , Leave your comments or Download question paper.

Question is ⇒ When a p-n Junction is forward biased, Options are ⇒ (A) the current flow is due to electrons only, (B) the majority carriers in both p and n materials are driven toward the junction., (C) the majority carriers in both p and n materials are away from the junction., (D) both (a) and (c)., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a p-n Junction is forward biased
A.	the current flow is due to electrons only [Wrong Answer]
B.	the majority carriers in both p and n materials are driven toward the junction. [Correct Answer]
C.	the majority carriers in both p and n materials are away from the junction. [Wrong Answer]
D.	both (a) and (c). [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the system of the given figure |G(jω)| = 0 dB at &omeg
0
1 rad/sec.
∞
2.38 rad/sec.

⇒ The system in the given figure,
good gain and phase margin
poor gain and phase margin
good gain margin but poor phase margin
poor gain margin but good phase margin

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	DBLSPACE	1.	Deletes a director and its sub-directories
B.	MEM	2.	Displays the amount of used and free memory
C.	SYS	3.	Put a copy of DOS on disk
D.	DELTREE	4.	Compresses files to increase the storage capacity of disc

A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-2, C-3, D-1
A-1, B-2, C-3, D-4

⇒ If the plate supply voltage for a plate modulated class C amplifier is E, the maximum plate cathode voltage could be almost as high as
E
2 E
3 E
4 E

⇒ In the given figure reflection coefficient at loa
0.6
-0.6
0.4
-0.4

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ The chip 8257 is a
programmable interrupt controller
programmable DMA controller
programmable peripheral interface
none of the above

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ The number of flip flops needed for a Mod 7 counter are
7
5
3
1

⇒

Match the following:

	List I		List II
A.	LED	1.	Heavy Doping
B.	Avalanche Photodiode	2.	Coherent Radiation
C.	Tunnel diode	3.	Spontaneous Emission
D.	LASER	4.	Current gain

A-2, B-4, C-3
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-2, B-1, C-4, D-3

⇒ The reverse saturation current in a semiconductor diode consists of
avalanche current
zener current
minority carrier current
minority carrier current and surface leakage current

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ Which of the following is correct?
Speed torque characteristics of permanent magnet dc servomotor is more flat than that of wound field dc servomotor
Speed torque characteristics of wound field dc servo- motor is more flat than that of permanent magnet dc servo motor
Speed torque characteristics of wound field and permanent magnet dc servomotor are equally flat
None of the above

⇒ A system has 12 poles and 2 zeros. Its high frequency asymptote in its magnitude plot has a slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ Two numbers are 131 ± 5 and 629 ± 3. The sum of the numbers with range of doubt is
760 ± 8
760 ± 2
760 + 8
760 - 8

⇒ Triatics are
small height antenna directly mounted on jeeps, ships, etc.
the towers or masts which are used as radiators
the towers or masts which are not used as radiators
supports for antenna conductors.

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ An antenna having an effective temperature of 27°K is fed into a microwave amplifier that has an effective noise temperature of 30 K. Calculate the available noise power per unit bandwidth
30 K
57 K
27 K
3K, K is Boltzmann constant

⇒ Cross talk is due to reception of portions of a signal from one channel into another.
TRUE
FALSE

⇒ The distance of poles from origin depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒ Consider the following statements as regards communication receiver

Variable sensitivity is used to eliminate selective fading
A product demodulator can be used to receive Morse code
The noise limiter cuts off receiver output during a noise pulse
Double conversion is used to improve image rejection

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ In figure the dc load line will meet the y and x axis respectivel
20 mA and 30 V
15 mA and 20 V
25 mA and 40 V
10 mA and 20 V

⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems