Question is ⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is, Options are ⇒ (A) changing, (B) reversing, (C) steady, (D) alternating, (E) , Leave your comments or Download question paper.

Question is ⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is, Options are ⇒ (A) changing, (B) reversing, (C) steady, (D) alternating, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is
A.	changing [Wrong Answer]
B.	reversing [Wrong Answer]
C.	steady [Wrong Answer]
D.	alternating [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ ALU carries out
arithmetic operations
logic operations
both arithmetic and logic operations
none of the above

⇒ Signal to noise ratio of microphone is defined as the ratio of output when the sound pressure is __________ to the output in the absence of any sound signal.
0.5 Pa
0.2 Pa
0.1 Pa
0.01 Pa

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ In a uniform plane wave E and H are related by
E/H = 1
E/H = ε/μ
E/H = μ/ε
none of the above

⇒ Radiation pyrometer is used to measure temperature in the range of
-200 to 500° C
0 to 500° C
500 to 1200° C
1200 to 2500° C

⇒ The frequency response of a microphone means
bandwidth of frequencies having output with in ± 1 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 1 dB of the output at 500 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 500 Hz

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ If the number of ways an event may result ins analysed into m successes and n failures, each equally likely to occur, the probability of success in a single trial is m( m + n)
TRUE
FALSE

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ In a N-P-N transistor of the emitter junction is reverse biased and collector junction is also reversed biased, the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ In a series inverter
the commutating elements carry full load current
the commutating elements carry upto 50% of load current
the commutating elements do not carry load current
any of the above

⇒ The minimum number of equations required to analyze the circuit shown in the figur
3
4
6
7

⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
divide by 5 circuit
divide by 2 circuit
divide by 5 circuit followed by divide by 2 circuit
BCD counter

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ In a four variable K map eight adjacent cells give
single variable term
two variable term
three variable term
four variable term

⇒ An audio signal (say from 50 Hz to 10000 Hz) is frequency translated by a carrier having a frequency of 10⁶ Hz. The values of initial (without frequency translation) and final (after frequency translation) fractional change in frequency from one band edge to the other are
200 and 1.01
200 and 10.01
200 and 100.1
200 and 200

⇒ The 8086 arithmetic instruction work on

signed and unsigned numbers
ASCII data
unpacked BCD data

Select the correct answer using the codes given below :
1 and 2
1 and 3
2 and 3
1, 2 and 3

⇒ A typical error rate on satellite circuits is one bit error in
10⁷
10³
10²
10¹⁰

⇒ A stepper motor is essentially
a synchronous motor
induction motor
dc motor
either (b) or (c)

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is
0.25
0.33
0.5
1

⇒ If f(t) = r (t - a), F(s) =
e^-as/s²
a/(s + a)
1/(s + a)
e^-as/s

⇒ A specimen of a material has a resistivity of 1.78 x 10⁸ ohm-m. The material is
semiconductor
conductor
semiconductor or conductor
insulator

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above