Question is ⇒ When a BJT is operated under saturated condition, Options are ⇒ (A) both junctions are forward biased, (B) both junctions are reverse biased, (C) CB junction is forward biased and EB junction is reverse biased, (D) EB junction is forward biased and CB junction is reverse biased, (E) , Leave your comments or Download question paper.

Question is ⇒ When a BJT is operated under saturated condition, Options are ⇒ (A) both junctions are forward biased, (B) both junctions are reverse biased, (C) CB junction is forward biased and EB junction is reverse biased, (D) EB junction is forward biased and CB junction is reverse biased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a BJT is operated under saturated condition
A.	both junctions are forward biased [Correct Answer]
B.	both junctions are reverse biased [Wrong Answer]
C.	CB junction is forward biased and EB junction is reverse biased [Wrong Answer]
D.	EB junction is forward biased and CB junction is reverse biased [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure the output v(t)
an amplitude modulated signal
a frequency modulated signal
a phase modulated signal
none of the above

⇒ In a purely inductive ac circuit, the supply voltage and voltage induced across inductance are equal and opposite at all instants.
TRUE
FALSE

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒

Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of these has poor overload capacity?
PMMC instrument
Hot wire instrument
Dynamometer instrument
Both (a) and (c)

⇒ India's Polar Satellite Launch vehicle (PSLV) to be ready in 1991 is designed to launch 1000 kg spacecraft into __________ orbit.
geostationary
equatorial
polar
sun-synchronous polar

⇒ Consider the following statements about 'Functions' in C

A function can be called any number of times.
A function gets called when the function name is followed by a semicolon.
The order in which functions are defined in a program and the order in which they are called must be the same.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒ A lag compensator is essentially a
low pass filter
high pass filter
band pass filter
either (a) or (b)

⇒ Which of the following devices has metal-silicon junction?
General purpose power diode
Schottky diode
SCR
MOSFET

⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
a, b, d
a, b, c
all
a, b, g, c, d

⇒ In a superheterodyne receiver, the IF is 455 kHz. If it is tuned to 1200 kHz, the image frequency will be
1655 kHz
2110 kHz
745 kHz
910 kHz

⇒ The work function of a photo surface whose threshold wave length is 1200 A, will be
0.103 eV
0.673 eV
1.03 eV
1.27 eV

⇒

Assertion (A): Silicon is preferred over germanium in manufacture of semiconductor devices.

Reason (R): Forbidden gap in silicon is more than that in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Diamagnetic materials do not have permanent magnetic dipoles.
TRUE
FALSE

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ Which 8085 instruction causes exchange of contents of stack pointer with the contents of H L register pair?
XTHL
PCHL
LHLD
MVIA

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ A plane EM wave is travelling in an unbound loss less dielectric having μ_y = 1 and ε_y = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity v_p (assuming velocity of light as 3 x 10⁸ m/sec) is
1.5 x 10⁸ m/sec
3 x 10⁸ m/sec
2.5 x 10⁸ m/sec
0.5 x 10⁸ m/sec

⇒ An electron rises through a voltage of 100 V. The energy acquired by it will be
100 eV
100 joules
(100)^1.2 eV
(100)^1.2 joules

⇒ Radiation intensity does not depend upon
the antenna direction
antenna width
both (a) and (b)
none of the above

⇒ In Z_RC (s) = 0 at s =∞, the last element in second Foster realization will be
R
C
R and C in series
R and C in parallel

⇒ The average noise temperature of Earth, as viewed from space, is __________ °K.
254
303
100
500

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ Consider the following statements

Gunn diode can be used in combinational logic circuits.
Gunn diode can be used in sequential logic circuits.
Both Gunn diode and GaAs Mesfet can be used in logic circuits.

Which of the above statements are correct?
1, 2, and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ In 8085, out of interrupts given below, one particular interrupts is quite different from others, This interrupt is
RST 5.5
RST 6.5
RST 7.5
none of these

⇒ The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by
A ← A + B
A ← AB
A ← A + B
A ← AB

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)