Question is ⇒ When a bit is 0 is a DDR, it makes the corresponding port pin an __________ On the other hand, a 1 bit programs a __________ Pin., Options are ⇒ (A) output, input, (B) output, output, (C) input, input, (D) input, output, (E) , Leave your comments or Download question paper.

Question is ⇒ When a bit is 0 is a DDR, it makes the corresponding port pin an __________ On the other hand, a 1 bit programs a __________ Pin., Options are ⇒ (A) output, input, (B) output, output, (C) input, input, (D) input, output, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a bit is 0 is a DDR, it makes the corresponding port pin an __________ On the other hand, a 1 bit programs a __________ Pin.
A.	output, input [Wrong Answer]
B.	output, output [Wrong Answer]
C.	input, input [Wrong Answer]
D.	input, output [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a flexible cable, most suitable insulation is
magnesium oxide
glass fibre
insulating tape
polyvinyl chloride

⇒ A system is highly oscillatory if
gain margin is high
gain margin is close to 1
gain margin is close to 1 or phase margin is zero
gain margin is high and phase margin is 180°

⇒

Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length

Reason (R): When line is terminated in resistance R_L, the standing wave ratio is SWR = Z₀/R_L or R_L/Z₀

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An 8 level encoding scheme is used in a PCM system of 10 kHz channel BW. The channel capacity is
80 kbps
60 kbps
30 kbps
18 kbps

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ If f₁ and f₂ and half-power frequency and f₀ be resonant frequency, the selectivity of R-L-C series circuit is given by
(f₂ - f₁)/2f₀
(f₂ - f₁)/f₀
(f₂ - f₀)/(f₁ - f₀)
(f₂ - f₁)/(f₁ - f₀)

⇒ A system has 12 poles and 2 zeros. Its high frequency asymptote in its magnitude plot has a slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ The relation between plate current and plate voltage of a vacuum diode is called
Richardson Dushman equation
Langmuir Child law
Ohm's law
Boltzmann's law

⇒ The chemical effect of current is used in
dc ampere hour meter
dc ammeter
ac energy meter
all of the above

⇒ A varactor diode is
reverse biased
forward biased
biased to breakdown
unbiased

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ In a single phase full wave ac regulator the firing angles during both half cycles are equal.
TRUE
FALSE

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ Which of the following is not a necessary advantage of negative feedback system?
Feedback improves speed of response
Feedback improves stability
Feedback reduces effect of variations in system parameters
Feedback reduces the effect of external disturbances

⇒ Brownian motion is
random emission of electrons in vacuum tubes
thermal motion of electrons in a resistance
random diffusion of holes and electrons in semi- conductors
both (b) and (c)

⇒ Which one of the following is a trivalent material?
Antimony
Phosphorus
Arsenic
Boron

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ Both OR and AND gates can have only two inputs.
TRUE
FALSE

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ Let the initial contents of ACC and CY in 8085 be

CY = 1
ACC = 10000001

After the instruction RAL is executed twice the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000111
1 and 00000111
0 and 00000011

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ BCD number 1100111 = __________ ₁₀
66
67
68
69

⇒ Noise can be measured by
D.C. voltmeter
A.C. voltmeter
either of the above
none of the above

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ For the K map of the given figure the simplified Boolean expressio
A + BC
A + BC
A + B C
A + B C

⇒ Contents of RAM cannot be altered.
TRUE
FALSE

⇒ The most commonly used logic family is
ECL
TTL
CMOS
PMOS

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ The subcarrier frequency for transmission of colour difference signals in TV systems in India is
9.47 MHz
4.43 MHz
2.06 MHZ
1.3 MHz