Question is ⇒ What will be the propagation constant at 10 MHz?, Options are ⇒ (A) 3.4 radians/km, (B) 34.4 radians/km, (C) 344 radians/km, (D) 3440 radians/km, (E) , Leave your comments or Download question paper.

Question is ⇒ What will be the propagation constant at 10 MHz?, Options are ⇒ (A) 3.4 radians/km, (B) 34.4 radians/km, (C) 344 radians/km, (D) 3440 radians/km, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What will be the propagation constant at 10 MHz?
A.	3.4 radians/km [Wrong Answer]
B.	34.4 radians/km [Wrong Answer]
C.	344 radians/km [Correct Answer]
D.	3440 radians/km [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Parallel adder is
sequential circuit
combinational circuit
either sequential or combinational circuit
none of the above

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ If i = 10 + 12 cos 500t - 3.5 sin 500 t, then in amplitude phasse form i =
10 + 12.5 sin (500 t + 106.20°)
5 + 12.5 sin (500 t + 106.20°)
10 + 11 sin (500 t + 106.20°)
10 + 12.5 sin (500 t + 10°)

⇒ A universal shift register can shift
from left to right
from right to left
both from left to right and right to left
none of the above

⇒ In 8085, to disable the whole interrupt system (except TRAP)
the DI instruction may be used
the DO instruction may be used
the INTERRUPT instruction may be used
the El instruction may be used

⇒

Assertion (A): A resistor is a passive load and a transistor is an active load

Reason (R): Op-amp is mostly used in feedback mode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease

⇒ The minimum permissible size of aluminium cable for lighting circuit is
1.2 sq. mm
1.5 sq. mm
2.2 sq. mm
3.5 sq. mm

⇒ A negative feedback can be of
2 types
3 types
4 types
only 1 type

⇒ Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
t_s - t_r
t_s - t_f
t_d + t_r
2t_r

⇒ In push pull amplifier, each transistor conducts for
180°
360°
90°
45°

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque

⇒ A 10 bit D/A converter gives a maximum output of 10.23 V. The resolution is
10 mV
20 mV
15 mV
25 mV

⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
252 sin (20000t + 45°)
252 sin (20000t - 45°)
252 sin 20000t
252 sin (20000t - 90°)

⇒ In the given figure shows a logic circuit. The minimum Boolean expression for this circui
A + B
A + B + C
AB + C
AB + AC + BC

⇒

Assertion (A): In KVL equations involving mutually coupled circuits the sign of M terms can be positive or negative.

Reason (R): Dot convention helps in determining sign of M terms in KVL equations.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A Darlington pair has β = 300. If R_E = 1 kΩ and R_L = 100 Ω, the input impedance at the base is approximately
300 k ohm
3 k ohm
100 k ohm
30 k ohm

⇒ Regarding TASI which one of the following statements is wrong?
It snatches the channel in his speech and may allocate it to another speaker needing it.
The same speaker is reassigned a channel almost instantly when he speaks again even when the circuit is heavily loaded.
It increases the overall utilization of the transmission channel
Intercontinental callers sometimes confuse the effects of TASI with the effects of satellite delay.

⇒ Which of the following introduces mode partition noise?
Coaxial line
Waveguide
Fibre transmission line
Both coaxial line and waveguide

⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ In a biased JFET (Figure) the shape of the channel is as shown bec
it is the property of material used
the drain end is more reverse biased than source end
drain end is more forward biased than source end
impurity profile changes with distance

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ With a variable reluctance tachometer having 60 rotor teeth the count reads 3600 counts per minute. The speed in RPM is
36
60
360
3600

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ The units of μ₀ and μ_r are
H/m for both
H/m for μ_r and no units for μ₀
H/m for μ₀ and no units for μ_r
Wb/m for μ₀ and no units for μ_r

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒

Assertion (A): In SSB, carrier is suppressed by about 45 dB

Reason (R): SSB is standard form for radio communication

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40
4.878
1.212