Question is ⇒ What is the simplest formula of a compound containing 50% of element A (atomic weight = 10) and 50% of element B (atomic weight = 20) ?, Options are ⇒ (A) AB3, (B) A2B3, (C) A2B, (D) AB2, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the simplest formula of a compound containing 50% of element A (atomic weight = 10) and 50% of element B (atomic weight = 20) ?, Options are ⇒ (A) AB3, (B) A2B3, (C) A2B, (D) AB2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the simplest formula of a compound containing 50% of element A (atomic weight = 10) and 50% of element B (atomic weight = 20) ?
A.	AB₃ [Correct Answer]
B.	A₂B₃ [Wrong Answer]
C.	A₂B [Wrong Answer]
D.	AB₂ [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Gases having same reduced temperatures and reduced pressures
deviate from ideal gas behaviour to the same degree.
have nearly the same compressibility factor.
both (a) and (b).
neither (a) nor (b).

⇒ The weight fraction of methanol in an aqueous solution is 0.64. The mole fraction of methanol X_M satisfies
X_M < 0.5
X_M = 0.5
0.5 < X_M < 0.64
X_M ≥ 0.64

⇒ Solution made by dissolving equimolar amounts of different solutes in the same amount of a given solvent will have the
same elevation in boiling point.
different elevation in boiling point.
elevation in boiling point in the ratio of their molecular weights.
none of these.

⇒ C_p - C_v, for an ideal gas is equal to
R
R/2
2R
3R

⇒ In general, the specific heats of aqueous solutions __________ with increase in the concentration of the solute.
increase
decrease
remain unchanged
none of these

⇒ Which of the following is not a colligative property ?
Osmotic pressure
Depression of freezing point
Lowering of vapor pressure
none of these.

⇒ NaOH contains __________ percent oxygen.
1
10
16
40

⇒ Which of the following is not a unit of pressure ?
Torr
Newton/m²
Parsec
Ata, bar or pascal

⇒ A solution with reasonably permanent pH is called a/an __________ solution.
ideal
non-ideal
buffer
colloidal

⇒ Assuming applicability of ideal gas law, the pure component volume of the vapor in a saturated gas can be calculated from theoretical relationship. The volumetric composition of a vapor saturated gas is independent of the
nature of the liquid.
nature of the gas.
temperature of the liquid. id) total pressure.

⇒ Which of the following is not a unit of length ?
Parsec
Angstrom
Barn
Fermi

⇒ A butane isomerisation process produces 70 kmole/hr of pure isobutane. A purge stream removed continuously, contains 85% n-butane and 15% impurity (mole%). The feed stream is n-butane containing 1% impurity (mole%). The flow rate of the purge stream will be
3 kmole/hr
4 kmole/hr
5 kmole/hr
6 kmole/hr

⇒ "The heat capacity of a solid compound is approximately equal to the sum of the heat capacities of the constituent elements." This is the statement of
Law of Petit and Dulong
Kopp's rule
Nearnst heat theorem
Trouton's rule

⇒ Average molecular weight of air is about
21
29
23
79

⇒ 1 kg/m² is equal to __________ mm water column.
1
10
100
1000

⇒ Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m³ . The diffusivity of aniline in air is 0.74xl0^-5m²/s.The numerical value of mass transfer co-efficient is 7.4 x 10^-3. Its units are
m/s
cm/s
mole/m².s.Pa
kmole/m².s.Pa

⇒ Heat capacity of air can be approximately expressed as, C_p = 26.693 + 7.365 x10^-3 T, where, C_p is in J/mole.K and T is in K. The heat given off by 1 mole of air when cooled at atmospheric pressure from 500°C to - 100°C is
10.73 kJ
16.15 kJ
18.11 kJ
18.33 kJ

⇒ Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m³ . The diffusivity of aniline in air is 0.74xl0^-5m²/s.The numerical value of mass transfer co-efficient is 7.4 x 10^-3. The rate of evaporation of aniline is 2.97 x 10^-4. Its units are
mole/s
mole/cm². s
mole/m² . s
kmole/m² . s

⇒ Under conditions of equal reduced pressure and equal reduced temperature, substances are said to be in the 'corresponding states'. At equal reduced conditions i.e., at the corresponding state, the __________ of different gases are nearly the same.
compressibility
molecular weight
humidity
none of these

⇒ PH value of a solution containing equal concentration of hydroxyl and hydrogen ions will be
0
10
7
14

⇒ 1 torr is equal to __________ mm Hg column.
1
0.1
10
1000

⇒ 1 BTU/lb.^←°F is equivalent to __________ kcal/kg.°C.
1
2.42
1.987
4.97

⇒ Saturated molal absolute humidity of the vapor-gas mixture depends upon the
vapor pressure at dry bulb temperature
total pressure
both (a) and (b)
neither (a) nor (b)

⇒ In the reaction, Ca + 2H₂O = Ca(OH)₂ + H₂ ; what volume (c.c.) of hydrogen at STP would be liberated, when 8 gm of calcium reacts with excess water ? (atomic weight of calcium = 40)
4480
2240
1120
0.4

⇒ The density of a gas 'X' is twice that of another gas 'Y'. If the molecular weight of gas 'Y' is 'M'; then the molecular weight of the gas 'X' will be
2M
M/2
M
M/4

⇒ One 'Therm' is equivalent to
10⁵ BTU
10⁵ kcal
10⁹ BTU
10⁹ kcal

⇒ The value of gas constant 'R' is __________ kcal/kg.mole.°C.
2.79
1.987
3.99
none of these

⇒ At higher temperatures, molal heat capacities for most of the gases (at constant pressure) __________ with increase in temperature.
varies linearly
increases
decreases
does not vary

⇒ Pick out the wrong unit conversion.
1 Joule = 4.186 calorie.
1 kcal = 3.968 BTU = 0.00116 kWh = 0.00156 hp.
1 ton of TNT (tri-nitro-toluene) = 4.2 GJ (1G = 10⁹).
1 ft.lbf= 0.3238 calorie = 0.1383 kg.m = 1.356 J = 1.356 N.m.

⇒ In a binary liquid system, the composition expressed as __________ is independent of the temperature & pressure.
kg of solute/kg of solvent
kg-mole of solute/kg-mole of solvent
kg-mole of solute/1000 kg of solvent
all (a), (b) & (c)