Question is ⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600, Options are ⇒ (A) -600 V, (B) Zero, (C) 600 V, (D) 1200 V, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600, Options are ⇒ (A) -600 V, (B) Zero, (C) 600 V, (D) 1200 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the RF amplifier plate voltage when the audio-modulating voltage is +600
A.	-600 V [Wrong Answer]
B.	Zero [Wrong Answer]
C.	600 V [Correct Answer]
D.	1200 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒

Match the following:

	List I		List II
A.	CLP	1.	Measure of μP clock speed
B.	SHELL	2.	Double sided double density
C.	DSDD	3.	Allows you to specify file as command processor
D.	Megahertz	4.	Microcode stored in ROM

A-4, B-3, C-2, D-1
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor

⇒ Which one of the following is a trivalent material?
Antimony
Phosphorus
Arsenic
Boron

⇒ Ferrites have
a low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ Which of the following statement number is not valid in Basic
12
521
662512
99999

⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ In a series RLC circuit p.f is lagging when f < resonance frequency.
TRUE
FALSE

⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above

⇒ Which one of the following is loaded in the main memory by the bootstrap loader?
System data
User program
BIOS
Part of DOS

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ The minimum gate source voltage that creates the n-type inversion layer is called
cut off voltage
on voltage
threshold voltage
zener voltage

⇒

Match the following:

	List I (Signal)		List II (Value)
A.	AM	1.	0 0.5
B.	DSB - SC	2.	1
C.	SSB	3.	2
D.	FM (β = 2)	4.	16
E.	FM (β = 5)	5.	8

A-1, B-3, C-2, D-5, E-4
A-3, B-3, C-1, D-5, E-4
A-2, B-1, C-4, D-5, E-5
A-4, B-2, C-5, D-3, E-1

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A/D parallel converter is also called flash converter.
TRUE
FALSE

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ The discrete time system describes by y(n) = x(n²) is
casual, Linear, time varying
casual, non-linear, timevari
non-casual, Linear, time invariant
non-casual, non-linear, time variant

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ Frequency shifting keying is basically a method involving
amplitude modulation
frequency modulation
phase modulation
none of the above

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3