Question is ⇒ What is the purpose of using ALE signal high?, Options are ⇒ (A) To latch low order address from bus to separate A0 - A7 lines, (B) To latch data D0 - D7 from bus to separate data bus, (C) To disable data bus latch, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the purpose of using ALE signal high?, Options are ⇒ (A) To latch low order address from bus to separate A0 - A7 lines, (B) To latch data D0 - D7 from bus to separate data bus, (C) To disable data bus latch, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the purpose of using ALE signal high?
A.	To latch low order address from bus to separate A₀ - A₇ lines [Correct Answer]
B.	To latch data D₀ - D₇ from bus to separate data bus [Wrong Answer]
C.	To disable data bus latch [Wrong Answer]
D.	All of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085, the pairing of registers B, C, D, E, H, L is
B - C, D - E, H - L
B - D, C - E, H - L
B - C, D - L, H - E
B - H, D - E, C - L

⇒ To couple a coaxial line to a parallel wire line, it is best to use a
balun
slotted line
quarter wave transformer
directional coupler

⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3

⇒ In case of probability of the message is 1 to 16 then the information will be
16 bits
8 bits
4 bits
2 bits

⇒

Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In VCR the luminance signal is recorded by
frequency modulation
phase modulation
amplitude modulation
direct recording

⇒ In a P-N-P transistor, electrons flow
into the transistor at the collector only
into the transistor at the base and the collector leads
out of the transistor at base and collector leads
out of the transistor at base, collector as well as emitter leads

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port
10 mW
15 mW
20 mW
25 mW

⇒

Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The 1150 kg geosynchronous satellite INSAT-IA parked 36000 km above India had greatly improved India's
intelligence gathering capacity
domestic communications
meteorological capability
both (b) and (c)

⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ The Truth Table shown is f
CMO
counter
flip-flop
half adder

⇒ A carrier wave carries information.
TRUE
FALSE

⇒ In a P-N-P junction transistor as compared to base region is more heavily doped so that
leakage current is minimized
recombination will be increased in the base region
the flow across the base regional is only because of electrons
the flow across the base region is mainly because of holes

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ In an n-type silicon crystal at room temperature, which of the following can have a concentration of 4 x 10¹⁹ cm^-3?
Silicon atoms
Holes
Dopant atoms
Valence electrons

⇒ For an N bit ADC, the percentage resolution is [1/2^N - 1)] 100.
TRUE
FALSE

⇒ Which inductor is linear?
Air cored
Cast iron cored
Sheet steel cored
Iron alloy cored

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒ Two identical NMOS transistors M₁ and M₂ are connected as shown below. V_bias is chosen so that both transistors are in saturation. The equivalent g_m of the pair is defined t
the sum of individual g_m's of the transistors
the product of individual g_m's of the transistors
nearly equal to the g_m of M₁
nearly equal to g_m / g₀ of M₂

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒ Which one of the following is loaded in the main memory by the bootstrap loader?
System data
User program
BIOS
Part of DOS

⇒ A universal shift register can shift left or right.
TRUE
FALSE

⇒

Assertion (A): In a perfect capacitor, the current density is given by ω ∈₀E₀∈^'_rcos(ωt + 90°), where ∈_r^' is real part of dielectric constant.

Reason (R): In a perfect capacitor, dielectric losses are zero.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ How many distinct binary trees can be constructed with three nodes?
1
2
3
5

⇒ A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as
Fermi's effect
Photo electric effect
Joule's effect
Hall's effect