Question is ⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?, Options are ⇒ (A) 0.6698, (B) 0.7698, (C) 0.503, (D) 0.6598, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?, Options are ⇒ (A) 0.6698, (B) 0.7698, (C) 0.503, (D) 0.6598, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
A.	0.6698 [Correct Answer]
B.	0.7698 [Wrong Answer]
C.	0.503 [Wrong Answer]
D.	0.6598 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒

Assertion (A): In register indirect addressing mode of 8085, the address of operand is in the specified register.

Reason (R): An example of register indirect addressing mode is MOV, A, M..

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ In level clocking the output can change
on rising edge of clock cycle
on falling edge of clock cycle
during entire half cycle of the clock
none of the above

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is
1
0.8
0.6
0.4

⇒ Consider the following DO statement in FORTRAN 77 7
6
1
8

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ Kelvin's double bridge is used to measure low resistances because
it has high sensitivity
there is no thermoelectric emf
resistance variation due to temperature
effect of contact and lead resistances is eliminated

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ In D-type FF, Preset (Pr) and clear (Clr) inputs are called
Synchronous
Asynchronous
Data
None

⇒ Which stage generates RF carri
Amplifier
Oscillator
Power supply
All of the above

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ Geosynchronous communication satellites travel around the earth in circular orbits with a forward speed of about __________ km/h.
11200
0
36000
22800

⇒ The impedance of a coil above self-resonant frequency is
inductive
capacitive
resistive
none

⇒ Some words like READ, WRITE, STOP etc. cannot be used as variable names in Fortran 77.
TRUE
FALSE

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ The order of the differential equa
1
2
3
4

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ The filter circuit for feeding a wooffer has
an inductance in series and capacitance in parallel
a capacitance in series and an inductance in parallel
a resistance in series and an inductance in parallel
an inductance in series and a resistance in parallel

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ Which of the following statement number is not valid in Basic
12
521
662512
99999

⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ The circuit shown in the figure
positive logic OR circuit
negative logic OR circuit
positive logic AND circuit
negative logic AND circuit

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE