Q1. | What is the frequency of the modulated carrier wave? |

A. | 1000 Hz [Wrong Answer] |

B. | 2000 Hz [Wrong Answer] |

C. | 1000 kHz [Wrong Answer] |

D. | 2000 kHz [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ For high frequencies a capacitor like

an open circuit

a short circuit

either open circuit or short circuit

none of the above

⇒ An SSB-AM signal cannot be demodulated by

Balanced modulator

Complete phase shift generator

Diode balanced modulator

Product detector

⇒ Resistivity of hard drawn copper is

less than that of annealed copper

more than that of annealed copper

same as that of annealed copper

decreasing when temperature increases

⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V

_{AB}is equal to

24 V

8 V

- 8 V

- 24 V

⇒ If transmitted power is 10 kW, the field strength at a distance

*d*is 50 mV/m. If transmitted power is reduced to 2.5 kW, the field strength at the same point will be

25 mV/m

12.5 mV/m

6.25 mV/m

3.125 mV/m

⇒ In a wave the electric field lines are vertical. Then the wave is

horizontally polarized

vertically polarized

either (a) or (b)

neither (a) nor (b)

⇒ For a circular wave guide

cutoff frequency for TE

_{10}and TE

_{01}modes are same

cutoff frequency for TE

_{10}and TE

_{01}modes are different

cutoff frequency for TE

_{10}mode = twice the cutoff frequency for TE

_{20}mode

cutoff frequency for TE

_{10}mode = haf the cutoff frequency for TE

_{20}mode

⇒ A wire has a diameter

*d*and resistance R. If the diameter is made 3

*d*, the length and material remaining the same, the new value of resistance will be

R/3

3 R

R/9

9 R

⇒ Which of the following is a disadvantage of Vestigial Sideband (VSB) system?

Low video frequencies are attenuated

Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system

It results in a power boost of two video frequencies

It possess the advantages of both DSB and SSB system

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program?

35

25

25

⇒ The phase difference between them is __________ degrees.

15

50

60

105

⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:

9

11.11

data not sufficient

10

⇒

**Assertion (A):** A band elimination filter attenuates signals whose frequencies lie between the cutoff frequencies.

**Reason (R):** A band elimination circuit is very different from band pass circuit.

Both A and R are true and R is correct explanation of A

Both A and R are true and R is not the correct explanation of A

A is true but R is false

A is false but R is true

⇒ Maximum effective aperture (A

_{e})max of short dipole antenna is

1.119 λ

^{2}

0.119 λ

^{2}

1.19 λ

^{2}

1.919 λ

^{2}

⇒ A magnetron requires an external magnetic field with flux lines parallel to axis of cathode

TRUE

FALSE

⇒ A current increasing at the rate of 1A/s is passed through a 1 H inductor. At

*t*= 0,

*i*= 0. The flux linkages after 1 sec are

0.5 Wb-turn

1 Wb-turn

2 Wb-turn

4 Wb-turn

⇒ For very low frequencies, log magnitude for the given figur

0 dB

-3 dB

3 dB

10 dB

⇒ In a transmission line, losses due to dielectric heating are

proportional to voltage and inversely proportional to Z

_{0}

proportional to voltage and proportional to Z

_{0}

proportional to current and proportional to Z

_{0}

proportional to current and inversely proportional to Z

_{0}

⇒ MICR stands for

Magnetic Ink Chart Receipt

Magnetic Ink Character Recognition

Magnetic Ink Chart Recognition

Magnetic Ink Character Receipt

⇒ The forbidden energy gap between the valence band and conduction band will be least in case of

metals

semiconductors

insulators

all of the above

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is

carbon-film

metal-film type

both have same tolerance

none of these

⇒ An op-amp integrating circuit uses

an inductor

a capacitor

both inductor and capacitor

none of the above

⇒

**Assertion (A):** For networks in figure (1) and (2) sum of products of branch voltages and branch currents at any time is zero.

**Reason (R):** The networks in figure (1) and (2) are not the same structura

Both A and R are true and R is correct explanation of A

Both A and R are true and R is not the correct explanation of A

A is true but R is false

A is false but R is true

⇒ A step up chopper can give an output voltage

higher than input voltage

lower than input voltage

both higher and lower input voltage

all of the above

⇒ A retriggerable one shot is one which

can be triggered only once

has two quasi stable states

can not be retriggered till the complete pulse appears at output

can be retriggered while the output is being generated

⇒ In the above case, what will be the value of capacitor to obtain 100 kHz frequency?

0.0065 pF

0.0130 pF

0.0260 pF

0.520 pF

⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is

2

12

0.707

0.5

⇒

List I | List II | ||
---|---|---|---|

A. | Darlington amplifier | 1. | A circuit using pnp and npn transistors |

B. | CB amplifier | 2. | A CS amplifier driving a CG amplifier |

C. | Cascade amplifier | 3. | A circuit with over-all voltage gain close to 1 and very large input impedance |

D. | Complementary symmetry amplifier | 4. | A circuit with low input impedance |

A-1, B-2, C-3, D-4

A-2, B-1, C-3, D-4

A-3, B-4, C-2, D-1

A-4, B-3, C-2, D-1

⇒ Find the FSV (full scale voltage) in a 6 bit R-2

*R*ladder D/A converter has a reference voltage of 6.5 V.

6.4 V

0.1 V

7 V

8 V

⇒ The operator precedence in Java is in the order

arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.

increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.

comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.

arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.