Question is ⇒ What is the frequency of audio modulation?, Options are ⇒ (A) 1000 Hz, (B) 2000 Hz, (C) 3000 Hz, (D) 2000 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the frequency of audio modulation?, Options are ⇒ (A) 1000 Hz, (B) 2000 Hz, (C) 3000 Hz, (D) 2000 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the frequency of audio modulation?
A.	1000 Hz [Wrong Answer]
B.	2000 Hz [Correct Answer]
C.	3000 Hz [Wrong Answer]
D.	2000 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Binary number 1101 is equal to octal number
17
16
15
14

⇒ The inconsistency of Ampere's law can be removed by adding __________ to it.
displacement current density alone.
conduction current density alone.
displacement and conduction current densities.
none of these

⇒ The number of doped regions in a bipolar junction transistor is
1
2
3
4

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300k will be (in m²/s).
0.43
0.16
0.04
0.01

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ The Boolean expression for the sub-class (Q) of all electronic instruments which are measuring instruments or are non-digital instruments with battery supply is
Q = X(Y + Z)
Q = X + YZ
Q = XY + Z
Q = XY + Z

⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ A variable reluctance tachometer has 180 teeth on rotor. The speed of shaft on which it is mounted in 1200 rpm. The frequency of output pulses is
1800 per second
3600 per second
4800 per second
5600 per second

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.
141.4
200
200/p
40/p

⇒ In an RC phase shift oscillator, the total phase shift of the three RC lead networks is
360°
180°
90°
0°

⇒ The angular location of poles depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ Consider the following
only statement 1 is correct
only statement 2 is correct
both statements are correct
both the statements 1 and 2 are not correct

⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception

⇒ The effect of negative feedback on distortion and bandwidth because
both are decreased
both are increased
distortion is reduced and bandwidth is increased
distortion is increased and bandwidth is decreased

⇒ In all insulators the bonding is covalent.
TRUE
FALSE

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒

Assertion (A): δ(t - b) is an impulse occuring at t = b

Reason (R): Intergal of unit impulse gives unit step function.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ A circular polarizer converts a linearly polarized wave into a circularly polarised wave.
TRUE
FALSE

⇒ An encoder converts decimal numbers to binary and other codes.
TRUE
FALSE

⇒ In a circuit containing a complex impedance, maximum power transfer takes place when load is
pure resistance
equal to the complex impedance
conjugate complex of the circuit impedance
none of the above

⇒ Transmitted voltage level is:
11
7.8
7.348 V
none of these

⇒ Consider the following statements:

Acceptor level is formed very close to the conduction band.
The effective mass of the free electron is same as that of a hole.
The magnitude of the charge of a free electron is same as that of a hole.
Addition of donor impurities adds holes to the semiconductor.

Which of the above statements are correct?
1 and 3
2 and 3
2 and 4
3 and 4

⇒ 1's complement of 11100110 is
11001
10000001
11010
0

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ