Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode? |

A. | The duration of output waveform is less than 180° [Wrong Answer] |

B. | Output voltage is less than input voltage [Wrong Answer] |

C. | Output voltage is more than input voltage [Wrong Answer] |

D. | Both (a) and (b) [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In the Taylor series expansion of exp(

*x*) + sin(

*x*) about the point

*x*= p, the coefficient of (

*x*- p)

^{2}is

exp (p)

0.5 exp (p)

exp (p) + 1

exp (p) - 1

⇒ A good dielectric should have

low losses

good heat conductivity

high intrinsic strength

all of the above

⇒ The maximum distance between television transmission and receiving antennas for reasonably good reception should be

less than 20 km

less than 100 km

less than 500 km

less than 1000 km

⇒ Available multiplexer IC package can have a maximum of 8 inputs.

TRUE

FALSE

⇒ The conductivity of materials found in nature ranges from 10

^{9}ohm

^{-1}m

^{-1}to nearly 10

^{18}ohm

^{-1}m

^{-1}from this it can be concluded that the conductivity of silicon in ohm

^{-1}cm

^{-1}will be nearly

0.5 x 10

^{-15}

0.5 x 10

^{-21}

0.5 x 10

^{-12}

0.5 x 10

^{-3}

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.

closed, open

open, closed

open, open

closed, closed

⇒ For the transmission of normal speech, the PCM channel needs a bandwidth of __________ kHz.

2

4

16

32

⇒ Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be

4 mW

1 mW

7 mW

1/4 mW

⇒ The materials having low retentivity are suitable for making

temporary smagnets

weak magnets

permanent magnets

both temporary and permanent magnets

⇒ The oscillator shown in figure

Clapp oscillator

R-C Phase shift oscillator

Hartley oscillator

Colpitt's oscillator

⇒ Consider the following statements

- Impedance of Gunn diode is about tens of ohms.
- Impedance of Impatt diode is a few ohms.
- Impedance of Impatt diode are of the same order.
- Impedance of Impatt diode is more than that of Gunn diode.

all

1 and 2 only

1, 2 and 3

1, 2 and 4

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is

0.1 kHz sinusoidal

10.1 kHz sinusoidal

a linear function

a constant

⇒ For the network of figure,

*z*

_{115/3 Ω3/2 Ω2 Ω2/3 Ω}

⇒ In figure V

_{BE}= 0.7 V. The base curren

above 97 μA

about 97 mA

about 75 μA

about 75 mA

⇒ The pressure coil of a wattmeter should be connected to the supply side of the current coil when

load impedance in high

load impedance is low

voltage is high

voltage is low

⇒ For an I/p of V

_{s}= 5 sin ω

*t*(assuming ideal diode), circuit shown in the figure will behave

clipper, sine wave clipped at -2 V

clamper, sine wave clamped at -2 V

clamper, sine wave clamped at 0 volts

clipper, sine wave clipped at 2 V

⇒ Wagner earthing device eliminates

all stray capacitance in the circuit

stray capacitances between components

stray capacitance between detector terminal and ground

mutual coupling between components

⇒ When a

*p*-

*n*-

*p*transistor is properly biased to operate in active region the holes from emitter.

diffuse through base into collector region

recombine with electrons in base

recombine with electrons in emitter

none of the above

⇒ The waveshape of output voltage of half bridge inverter is

sinusoidal

square

triangular

either (a) or (b)

⇒ An atom of a rare gas is placed is an electric field E. Then

the nucleus will be shifted in the direction of E by an amount which is proportional to E.

the nucleus will not be shifted.

the nucleus will be shifted in the direction of E by an amount which is independent of E.

the nucleus will be shifted in a direction opposite to that of E.

⇒ Which of the following is not the main characteristic of a FET?

Drain resistance

Forward transconductance

Temperature stability

Amplification factor

⇒ It two voltages are

*v*

_{1}= 100 sin (ω

*t*- 30°) and

*v*

_{2}= cos ω

*t*then

*v*

_{1}is leading

*v*

_{2}by 30°

*v*

_{2}is leading

*v*

_{1}by 30°

*v*

_{2}is leading

*v*

_{1}by 60°

*v*

_{1}is leading

*v*

_{2}by 60°

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about

13 mm

1.3 mm

130 mm

none of the above

⇒ In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition

A

_{v}→ ∞

1 << A

_{v}→ ∞

A

_{v}≈ 1

A

_{v}<< 1

⇒ Mark the false statement:

since wave-shape of a digital signal is unimportant, linear amplifiers are not required

the precise amplitude of a digital signal is also unimportant provided two voltage levels (0 and 1) are quite different

the leading and trailing edges of a digital signal need not be sharp

actual digital waves have rise and fall times of the order of a few nano seconds

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :

62831.9 V/sec

125663.8 V/sec

31415.95 V/sec

None

⇒ The function Z(

*s*) has a pole at infinity if

the degree of numerator and denominator of Z(

*s*) are equal

the numerator of Z(

*s*) is one degree higher than denominator

the denominator of Z(

*s*) is one degree higher than numerator

the degree of numerator and denominator are either equal or differ by one

⇒ In a reflex klystron the output frequency is determined primarily by resonant frequency of cavity.

TRUE

FALSE

⇒ A mobile telephone has a range of about

50 km

10 km

1 km

0.1 km

⇒ If the gate of JFET is reverse biased, the width of depletion region

becomes zero

is uniform

is more near the source

is more near the drain