Question is ⇒ What is the direction of control, Options are ⇒ (A) Unidirectional into μp, (B) Unidirection out of μp, (C) Bidirectional, (D) Mixed direction, i.e., some lines into μp an some others out of μp, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the direction of control, Options are ⇒ (A) Unidirectional into μp, (B) Unidirection out of μp, (C) Bidirectional, (D) Mixed direction, i.e., some lines into μp an some others out of μp, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the direction of control
A.	Unidirectional into μp [Wrong Answer]
B.	Unidirection out of μp [Wrong Answer]
C.	Bidirectional [Wrong Answer]
D.	Mixed direction, i.e., some lines into μp an some others out of μp [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ The V_o of the op-amp circuit shown in the give
11 V_i
10 V_i
V_i
zero

⇒ In a gate output is Low if and only if all inputs are High. The gate is
OR
AND
NOR
NAND

⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input
0°
90°
-90°
± 180°

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ The total number of leads in SCR, DIAC and TRIAC respectively are
3, 2, 3
2, 3, 3
3, 3, 2
3, 2, 4

⇒ In a practical oscillator, the magnitude of loop gain Aβ is kept slightly larger than unity and the amplitude of oscillations is limited by
the ratio of A to β
the on set of non-linearity of amplifying device
the linearity of amplifying device
all of the above

⇒ The circuit shown in figure
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Bandwidth of an antenna is related with where Q is quality factor
Q ∝ B
Q ∝ 1/B
Q ∝ B²
Q ∝ 1/B²

⇒ In a full wave rectifier, the current in each of the diodes flows for
the complete cycle of the input signal
half cycle of the input signal
less than half cycle of the input signal
one-fourth cycle of the input signal

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ Find L_eq if each L is
4/3 H
1/3 H
2/3 H
3/2 D

⇒

Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.

Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For the output F to be 1 in the logic circuit shown, the input combination shoul
A = 1, B = 1, C = 0
A = 1, B = 0, C = 0
A = 0, B = 1, C = 0
A = 0, B = 0, C = 1

⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V₀/V_i should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor

⇒ The opposition of an inductor to current flow
depends only on the resistance of the coil
depends on the magnitude of the applied voltage
varies directly with frequency
varies inversely with frequency

⇒ For the two ports in figure, y₁₁ = 8 mho, y₁₂ = y₂₁ = -6 mho and y₂₂ = 6 mho. The values of Y_A, Y_B, Y_C respectively
2, 6, 6 mho
2, 6, 0 mho
2, 0, 6 mho
2, 6, 8 mho

⇒ When a material is in superconducting state and a magnetic field is applied
the superconducting property is not affected
the superconducting property may be affected and resistivity may increase from zero to a low value
the superconducting property may be destroyed
the material may become an insulator

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ Denominator polynomial of a transfer function of certain network
stable
oscillatory
unstable
depends on numerator polynomial

⇒ In figure, the current through 10 V batter
0
0.5 A charging
0.5 A discharging
none of the above

⇒ Which of the following is a computer language?
MS WORD
Page maker
MS EXCEL
LISP

⇒ For frequencies upto 1650 kHz __________ antenna is used
yagi
grounded
turnstile
marconi

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE