Question is ⇒ What is the direction of address, Options are ⇒ (A) Unidirectional into μp, (B) Unidirection out of μp, (C) Bidirectional, (D) Mixed direction, i.e., some lines into up and some others out of μp, (E) , Leave your comments or Download question paper.

Question is ⇒ What is the direction of address, Options are ⇒ (A) Unidirectional into μp, (B) Unidirection out of μp, (C) Bidirectional, (D) Mixed direction, i.e., some lines into up and some others out of μp, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is the direction of address
A.	Unidirectional into μp [Wrong Answer]
B.	Unidirection out of μp [Correct Answer]
C.	Bidirectional [Wrong Answer]
D.	Mixed direction, i.e., some lines into up and some others out of μp [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A memory system has a 9 chips. If MTBF of one clip is 900 000 hours, MTBF of complete memory system is
900000 hours
100000 hours
8100000 hours
1800000 hours

⇒ SWR for a transmission line is infinity when the load is

Short circuit
Complex impedance
Open circuit
Pure reactance

Of the above statements:
1, 3, 4 are correct
1 and 3 are correct
2, 3, 4 are correct
1, 2, 4 are correct

⇒ A BJT amplifier has a power gain of 0.5 from source to base. The power gain in dB is
-0.3 dB
-3 dB
-6 dB
-10 dB

⇒

Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ For the design of a sequential circuit having 9 states, minimum number of memory elements required is
3
4
5
9

⇒ Choose correct option
var (X + Y) = Var (X) + Var (Y)
var (X - Y) = Var (X) + Var (Y)
var (X + Y) = Var (X) x Var (Y)
Both (a) and (b)

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ The maximum forward current in case of signal diode is in the range of
1 A to 10 A
0.1 A to 1 A
few milli amperes
few nano amperes

⇒ A transmitter serial current contains
carrier frequencies
audio frequencies
radio frequencies
none of the above

⇒ Which characteristics of a memory chip is called dc characteristics?
Organisation
Timing characteristics
Physical dimensions
Power consumption and bus loading

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE

⇒ If a = 0.995, I_E = 10 mA, I_CO = 0.5 mA, then I_CEO will be
100 μA
25 μA
10.1 μA
10.5 μA

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
power supply
loudspeaker
AGC, video IF amplifier, RF amplifier
horizontal oscillator

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A current increasing at the rate of 1 A/s is passed through 1 F capacitor. At t = 0, i = 0. The charge stored after 1 second is
0.5 C
1 C
2 C
4 C

⇒ Baudot code is a six bit code.
TRUE
FALSE

⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ Fundamental mode is another name for
level operation
pulse operation
clock operation
none of these

⇒ A material has conductivity of 10⁵ mho/m and permeability of 4p x 10^-7 H/m. The skin depth at 9 GHz is
1.678 μm
26 μm
17 μm
32.32 μm

⇒ Each term in POS form is called max terms.
TRUE
FALSE

⇒ The function of shunt in an ammeter is to
by pass the current
increase sensitivity of meter
increase resistance of meter
all of the above

⇒ The cut off wavelength λ_c for TE₂₀ mode for a standard rectangles waveguide is
2/a
2a
a
2a²

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above