Question is ⇒ What happens when a paramagnetic material is heated above Curie temperature?, Options are ⇒ (A) It becomes diamagnetic, (B) It becomes nonmagnetic, (C) It becomes ferromagnetic, (D) It becomes anti-ferromagnetic, (E) , Leave your comments or Download question paper.

Question is ⇒ What happens when a paramagnetic material is heated above Curie temperature?, Options are ⇒ (A) It becomes diamagnetic, (B) It becomes nonmagnetic, (C) It becomes ferromagnetic, (D) It becomes anti-ferromagnetic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What happens when a paramagnetic material is heated above Curie temperature?
A.	It becomes diamagnetic [Correct Answer]
B.	It becomes nonmagnetic [Wrong Answer]
C.	It becomes ferromagnetic [Wrong Answer]
D.	It becomes anti-ferromagnetic [Wrong Answer]
View Answer 6 -6 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ Which of these commutation methods uses an auxiliary SCR?
Class A
Class B
Class C
Class D

⇒ In a circular waveguide TE₂₁ mode has lowest cutoff frequency
TRUE
FALSE

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ A waveguide twist is used to change the plane of polarization.
TRUE
FALSE

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A signal is sampled at 8 kHz and is quantized using 8 bit uniform quantizer. Assuming SNR_q for a sinusoidal signal, the correct statement for PCM signal with a bit rate of R is
R = 32 KbPs, SNR_q = 25.8 dB
R = 64 KbPs, SNR_q = 49.8 dB
R = 64 KbPs, SNR_q = 58.8 dB
R = 32 KbPs, SNR_q = 49.8 dB

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ A megger has a hand driven dc generator.
TRUE
FALSE

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ In the circuit, shown in figure, V₀ = V_i. The values of 1, m, n are: (x represents don't care conditi
0, 1, 1
∞, x, x
x, ∞, x
0, x, ∞

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ The dissipation at the collector is in the quiescent state and increases with excitation in the case of a
class A series fed Amplifier
class A transistor coupled Amplifier
class AB amplifier
class B amplifier

⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
180
120
90
60

⇒ The discrete time system describes by y(n) = x(n²) is
casual, Linear, time varying
casual, non-linear, timevari
non-casual, Linear, time invariant
non-casual, non-linear, time variant

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a purely inductive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ Which of these instruments is dynamometers type?
Wattmeter
Power factor meter
Frequency meter
Both (a) and (b)

⇒ A scheme shown below is to generate a wide band FM modulate sign
30
6
250
12

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ A nickel cadmium cell is an alkaline cell.
TRUE
FALSE

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ A resistive microwave load with Z_L = 150 Ω is connected to 50 Ω coaxial line. SWR is
more than 3
less than 3
equal to 3
either (a) or (c)

⇒ The maximum effective aperture of a microwave antenna which has a directivity of 900, will be
71.619 λ²
716.19 λ²
7161.9 λ²
71619 λ²