Question is ⇒ What does a link budget for satellite communication include?, Options are ⇒ (A) Total cost of satellite, (B) Cost of satellite plus launch vehicle, (C) Signal and noise levels is dB, (D) Margins of error permitted, (E) , Leave your comments or Download question paper.

Question is ⇒ What does a link budget for satellite communication include?, Options are ⇒ (A) Total cost of satellite, (B) Cost of satellite plus launch vehicle, (C) Signal and noise levels is dB, (D) Margins of error permitted, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What does a link budget for satellite communication include?
A.	Total cost of satellite [Wrong Answer]
B.	Cost of satellite plus launch vehicle [Wrong Answer]
C.	Signal and noise levels is dB [Correct Answer]
D.	Margins of error permitted [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ For a given carrier wave, maximum undistorted power is transmitted when value of modulation is
1
0.8
0.5
0

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current supplied by batter
0
0.208333333333333
less than 5A
infinity

⇒ Which of the following is true?
Intel 8080 was the ancestor of Intel 8085
Intel 8080 was the ancestor of Intel Z 80
Intel 8080 was the ancestor of both Intel 8085 and Z 80
Intel 8085 was the ancestor of Intel 8085

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ Which dc servomotor has minimum inertia?
Slotted armature construction
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ CMRR of an op-amp is about 0.1.
TRUE
FALSE

⇒ Which solid dielectric has highest temperature limit?
E
H
C
F

⇒ The purpose of using negative feedback in a op-amps is to
stabilize overall gain
increase output
stabilize overall gain and increase output
increase output and decrease input

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒ Gain of an antenna with a circular aperture of diameter 4 meter at frequency of 10 GHz, with directivity 60
60
100
30
90

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ In a bipolar transistor
recombination in base regions of both n-p-n and p-n-p transistor is low
recombination in base regions of both n-p-n and p-n-p transistors is high
recombination in base region of n-p-n transistor is low but that in p-n-p transistor is high
recombination in base region of p-n-p transistor is low but that in n-p-n transistor is high

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒

Match the following:

	List I (Logic family)		List II (Characteristic of logic family)
A.	TTL	1.	Maximum power Consumption
B.	ECL	2.	Highest Packing Density
C.	NMOS	3.	Least Power Consumption
D.	CMOS	4.	Saturated Logic

A-1, B-4, C-2, D-3
A-1, B-4, C-3, D-2
A-4, B-1, C-2, D-3
A-4, B-1, C-3, D-2

⇒

Assertion (A): The response of a network to unit impulse can be obtained directly from the network function.

Reason (R): The response of a network for any input can be obtained from impulse response.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A digital frequency counter can be converted to DVM by addition of a suitable
voltage controlled oscillator
D/A converter
power amplifier
operational amplifier

⇒

Assertion (A): In microprocessor 8085 DMA allows direct access to memory to speed up data transfer.

Reason (R): HOLD and HLDA signals are used for DMA operations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒ To ensure that a zener diode does not get destroyed
the applied voltage should not exceed breakdown voltage
the current should not exceed rated current
the current should be less than magnitude of barrier potential
both (a) and (b)

⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms

⇒ A dipole antenna of λ/8 length has an equivalent total loss resistance of 1.5 Ω. The efficiency of the antenna is
0.0089159
0.089159
0.89159
8.9159

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt