Question is ⇒ Waveguides are generally used above, Options are ⇒ (A) 20 MHz, (B) 100 MHz, (C) 200 MHz, (D) 1000 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Waveguides are generally used above, Options are ⇒ (A) 20 MHz, (B) 100 MHz, (C) 200 MHz, (D) 1000 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Waveguides are generally used above
A.	20 MHz [Wrong Answer]
B.	100 MHz [Wrong Answer]
C.	200 MHz [Wrong Answer]
D.	1000 MHz [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ The term 'Poisson's ratio' is connected with
strain gauge
LVDT
Bourden tube
capacitance transducer

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz

⇒ In an ac series RLC circuit the maximum phase difference between any two voltages can be
90°
45°
- 90°
180°

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒ For a P-N diode, the number of minority carriers crossing the junction depends on
forward bias voltage
potential barrier
rate of thermal generation of electron hole pairs
none of the above

⇒ Consider the following digital circu
1 and 2
3 and 4
1, 2 and 3
1, 2, 3 and 4

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_EQ will be
5.15 mA
5.2 mA
5 mA
990 mA

⇒

Match the following:

	List I		List II
A.	V_OH(min)	1.	2.4 V
B.	V_IH(min)	2.	1.5 V
C.	V_OL(max)	3.	0.4 V
		4.	2.0 V
		5.	0.8 V

A-1, B-3, C-4
A-1, B-4, C-3
A-5, B-4, C-3
A-1, B-5, C-2

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒ As the frequency increases, the absorption of ground wave by earth's surface
decreases
increases
remains the same
either (a) or (c)

⇒ The most commonly used semiconductor material is
silicon
germanium
mixture of silicon and germanium
none of the above

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ Which of the following is type declaration statement in C?
int bar
s = s + 1
king = horse + 1
prin = prin * prin

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ Microwave signals transmitted towards the sky are
strongly absorbed by the ionosphere
strongly reflected by the ionosphere
transmitted through the ionosphere
unable to reach the ionosphere because of strong absorption in the lower atmosphere

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD

⇒ As compared to AM, FM requires
narrow channel
same channel
2 to 3 times as large channel
7 to 15 times as large channel

⇒ The resistivity of ferrites is
very much lower than that of the ferromagnetic metals
slightly lower than that of the ferromagnetic materials
slightly higher than that of the ferromagnetic metals
very much higher than that of the ferromagnetic metals

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒ In a series RLC circuit the phase angle θ of impedance Z ∠θ is positive. The circuit will behave as
resistive circuit
RC circuit
RL circuit
either RL or RC circuit

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ If transmission bandwidth is doubled in FM, SNR is
doubled
raised four times
decreased four times
halved

⇒ The colour code of a carbon resistance is yellow-violet-orange silver. The value of resistance is
57000 Ω ± 5%
47000 Ω ± 10%
47000 Ω ± 5%
57000 Ω ± 5%