Question is ⇒ 'Wait' in PERT belongs to the category of, Options are ⇒ (A) Activity, (B) Node, (C) Event, (D) Motion, (E) , Leave your comments or Download question paper.

Question is ⇒ 'Wait' in PERT belongs to the category of, Options are ⇒ (A) Activity, (B) Node, (C) Event, (D) Motion, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	'Wait' in PERT belongs to the category of
A.	Activity [Correct Answer]
B.	Node [Wrong Answer]
C.	Event [Wrong Answer]
D.	Motion [Wrong Answer]
View Answer 12 -8 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Sensitivity analysis is a study of
comparison of profit and loss
comparison of assets and liabilities
change in output due to change in input
economics of cost and benefits of the project

⇒ PERT technique of network analysis is mainly useful for
small projects
large and complex projects
research and development projects
deterministic activities

⇒ In resources levelling
total duration of project is reduced
total duration of project is increased
uniform demand of resources is achieved
cost of project is controlled

⇒ Which one of the following does not fall under the category hoisting equipment ?
Chain hoist
Jack
Hoist winch
Dragline

⇒ A father notes that when his teenage daughter uses the telephone, she takes not less than 6 minutes for a call and som? times as much as an hour. Fifteen minutes call are more frequent than calls of any other duration. If these phone calls were an activity in PERT project, then phone calls expected duration will be
15 minutes
20.143 minutes
21 minutes
27 minutes

⇒ Sinking fund is
the fund for rebuilding a structure when its economic life is over
raised to meet maintenance costs
the total sum to be paid to the municipal authorities by the tenants
a part of the money kept in reserve for providing additional structures and structural modifications [ES 94]

⇒ 'Wait' in PERT belongs to the category of
Activity
Node
Event
Motion

⇒ In the network shown in Fig. , the critical path is
1-2-3-4-5-6
1-2-4-5-6
1-2-3-5-6
1-2-4-3-5-6

⇒ A four wheel trac*or whose operating weight is 12000 kg is pulled along a road having a rising slope of 2% at a uniform speed. Assume grade resistance factor = 10 kg/tonne. The tension in the tow cable is 720 kg. The rolling resistance of the road will be
20 kg/tonne
30 kg/tonne
40 kg/tonne
50 kg/tonne

⇒ Batching refers to
controlling the total quantity at each batch
weighing accurately, the quantity of each material for a job before mixing
controlling the quantity of each material into each batch
adjusting the water to be added in each batch according to the moisture content of the materials being mixed in the batch

⇒ The independent float affects only
preceding activities
succeeding activities
the particular activity involved
none of the above

⇒ Economic saving of time results by crashing
cheapest critical activity
cheapest non-critical activity
costliest critical activity
costliest non-critical activity

⇒ An excavator costs Rs. 20,00,000/- and has an estimated life of 8 years. It has no salvage value at the end of 8 years. The book value of the excavator at the end of 3 years using general double declining balance method is
Rs. 8,43,750/-
Rs. 8,75,000/-
Rs. 10,50,000/-
Rs. 11,56,250/-

⇒ In PERT technique, completion of an activity is called
Head activity
Head event
Tail Activity
Tail event

⇒ PERT analysis is based on
Optimistic time
Pessimistic time
Most likely time
All of these

⇒ Which of the following is a weakness of bar chart ?
interdependencies of activities
project progress
uncertainties
all of the above

⇒ The maximum rimpull in the first gear of a tractor while towing a load is 6300 kg. The tractor weighs 12.5 tonnes and is operating along a 2 percent upgrade and the rolling resistance is 45 kg/tonne. Pull available for towing the load is
3425 kg
5515 kg
4350 kg
2975 kg

⇒ Free float is mainly used to
identify the activities which can be delayed without affecting the total float of preceding activity
identify the activities, which can be delayed without affecting the total float of succeeding activity
establish priorities
identify the activities which can be delayed without affecting the total float of either the preceding or succeeding activities

⇒ Which one of the following, shovel excavators is considered most efficient in loading carriers ?
Dipper shovel
Dragline
Backhoe
Clamshell

⇒ Which of the following does not represent an activity?
site located
foundation is being dug
the office area is being cleaned
the invitations are being sent

⇒ Sand is produced by crushing in
Hammer mill
Ball mill
Gyrator
Jaw crusher

⇒ Mobilization advance up to 10% of the cost of work is given to a contractor
on commencement of work at site for payment of loan taken by him
for the purchase of construction materials
for the payment of advances to labour and other staff
for all activities required to start the work at site on finalization of the contract document [ES 94]

⇒ Which one of the following is not a part of the diesel engine ?
Fuel pump
Piston
Crankshaft
Spark plug

⇒ In the network shown in Fig. the latest start time of an activity 4-5 is
2
4
8
7

⇒ Less than Independent Float. Of these statements
1 and 4 are correct
2 and 3 are correct
1 and 4 are correct
1 and 2 are correct

⇒ The basic action involved in sheep foot rolling is
Kneading
Pressing
Tamping
Vibration

⇒ Critical path
Is always longest
Always shortest
May be longest
May be shortest

⇒ Crashing is
Reduction is duration
Reduction of resource
Reduction of cost
Reduction in project size

⇒ If the output of a dragline for 90° angle of swing at optimum depth of cut is X, then the output for 120° angle of swing at 120 % of optimum depth of cut will be
equal to X
more than X
less than X
any of the above

⇒ The compressor to be used for pressuring air to 10 kg is
Reciprocating type
Axial flow type
Centrifugal type
Lobe type