Question is ⇒ VSWR can have any value between, Options are ⇒ (A) 0 and 1, (B) - 1 to + 1, (C) 0 to ∞, (D) 1 to ∞, (E) , Leave your comments or Download question paper.

Question is ⇒ VSWR can have any value between, Options are ⇒ (A) 0 and 1, (B) - 1 to + 1, (C) 0 to ∞, (D) 1 to ∞, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	VSWR can have any value between
A.	0 and 1 [Wrong Answer]
B.	- 1 to + 1 [Wrong Answer]
C.	0 to ∞ [Wrong Answer]
D.	1 to ∞ [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In ionic bonding, the valence electron is donated by one atom and accepted by the other atom.
TRUE
FALSE

⇒ In order to receive a vertically polarized wave, the conductor of the dipole should be mounted
horizontally
vertically
at an angle of 45°
none of the above

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ In a parallel inverter
the commutating capacitor C is across the primary of transformer and the load is across the secondary
the commutating capacitor and load are connected across the secondary of transformer
the commutating capacitor C and load are connected in series and the combination is across the secondary of transformer
none of the above

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ In 2's complement form, - 2 is
1011
1110
1100
1010

⇒ If f₁(t)<< F₁(jω) and f₂(t)↔ F₂(jω), then [a₁ f₁(t) + a₂f₂(t)]↔
a₁F₁(jω) + a₂F₂(jω)
a₁a₂F₁(jω) + F₂(jω)
a₁F₁(jω) - a₂F₂(jω)
a₁F₁*(jω) + a₂F₂*(jω)

⇒ A(A + B) =
A
A B
AB
AB

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒

Assertion (A): In Fortran 77 the statement IMPLICIT INTEGER (A - E) identifies all variable name which begin with A, B, C, D, or E as being of integer type.

Reason (R): IMPICIT statement in Fortran 77 is an improvement over earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ The configuration of figure
Hartley oscillator
Precision Integrator
Wienbridge oscillator
Butterworth high pass filter

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒

Assertion (A): A slight change in pole-zero configuration can cause only minor changes in root locus configuration.

Reason (R): Asymptotes show the behaviour of root loci for |s| >> 1

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W

⇒ A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are
100 Hz and 50 Hz
50 Hz and 100 Hz
100 Hz each
50 Hz each

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ In a purely inductive ac circuit the power curve is a sinusoid of the same frequency as the voltage.
TRUE
FALSE

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ DeMorgan's first theorem is =
A . A = 0
A = A
A + B = A . B
AB = A + B