Question is ⇒ V<sub>th</sub> = 0, if, Options are ⇒ (A) there is no independent source in circuit, (B) there is no dependent source in circuit, (C) voltage source of infinite magnitude, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ V<sub>th</sub> = 0, if, Options are ⇒ (A) there is no independent source in circuit, (B) there is no dependent source in circuit, (C) voltage source of infinite magnitude, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	V_th = 0, if
A.	there is no independent source in circuit [Correct Answer]
B.	there is no dependent source in circuit [Wrong Answer]
C.	voltage source of infinite magnitude [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Higher order TDM levels are obtained by
forming super master groups
using A law
using μ law
dividing pulse width

⇒ Which multivibrator can be used as a clock timer?
Astable multivibrator
Bistable multivibrator
Any of the above
None of the above

⇒ In a common emitter circuit all voltages are measured with respect to
base
emitter
collector
base or collector

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The forbidden energy gap in semiconductors
is always zero
lies just below the valence band
lies between the valence band and the conduction band
lies just above the conduction band

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ Measuring of unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when
primary circuit battery is changed
standardisation is done to compensate for drift
voltage is larger than range of potentiometer
range reduction by factor of 10 is employed

⇒ A two-input OR gate is designed for positive logic. However, it is operated with negative logic. The resulting logic operation will then be
OR
AND
NOR
EX-OR

⇒ A single phase full wave regulator feeds R-L load. The best gating signal is
short duration pulses
long duration pulses
pulse train
either (a) or (b)

⇒ The present total cost per watt of power generation in geosynchronous orbit is nearly Rs.
20
50
100
5

⇒ Polar plot of a lag-lead compensator is a circle.
TRUE
FALSE

⇒ Microprocessor 8088 has
16 bit registers and 16 bit data bus
8 bit registers and 8 bit data bus
8 bit registers and 16 bit data bus
16 bit registers and 8 bit data bus

⇒ The mobile unit of a mobile telephone is generally in
vehicles
pocket
office
vehicle or pocket

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒ The resistance of a 125 Ω strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is
1.5
2
2.5
3

⇒ In which of the following semiconductor are holes minority carriers
extrinsic
p type
n type
intrinsic

⇒ For a 4096 x 8 EPROM, the number of address lines is
14
12
10
8

⇒ Consider the following rules for constructing variable names in C

It can have alphabets, digits or underscores but no other special character.
The maximum number of characters is 8.
The first character may be an alphabet or digit but not underscore.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
200 μC
400 μC
50 μC
25 μC

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ 1 GHz is equal to
10⁶ Hz
10⁸ Hz
10⁹ Hz
10¹⁰ Hz

⇒ In the spectrum of a frequency modulated wave
carrier frequency cannot disappear
carrier frequency vanishes when modulation index is large
the number of significant sidebands depends upon modulation index
none of the above

⇒ Carbon steel has a residual flux density of 1 Wb/m².
TRUE
FALSE

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above

⇒ In EM waves, polarization
is always vertical in an isotropic medium
is caused by reflection
is due to transverse nature of waves
results from longitudinal nature of waves

⇒ In decimal system the base of radix is
0
1
10
e

⇒ Speech amplifiers are usually operated as
class A
classes AB
class B
class C