Question is ⇒ Volt is equivalent to, Options are ⇒ (A) joule/coulomb, (B) joule/watt, (C) joule/ampere, (D) joule/volt, (E) , Leave your comments or Download question paper.

Question is ⇒ Volt is equivalent to, Options are ⇒ (A) joule/coulomb, (B) joule/watt, (C) joule/ampere, (D) joule/volt, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Volt is equivalent to
A.	joule/coulomb [Correct Answer]
B.	joule/watt [Wrong Answer]
C.	joule/ampere [Wrong Answer]
D.	joule/volt [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25

⇒ The types of carriers in a semiconductor are
1
2
3
4

⇒ In figure v₁ = 8 V and v₂ = 4 V. Which diode will cond
D₂ only
D₁ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ In the circuit below, the diode is ideal. The voltage V is give
min(V_i, 1)
max(V_i, 1)
min (-V_i, 1)
max (-V_i, 1)

⇒ PA radar means
Phased Array radar
Pulsed Array radar
Pulse Amplitude radar
None of the above

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ Read the following statements:

A μP generally interfaced to several memory chips and I/O devices
Address space provided by μP is partitioned into sub sets of addresses
Address map and address partition refer to different terms in address space

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1, 3 only

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ Full duplex operation
requires modems at both ends of circuit
requires two pairs of cables
can transfer data in both directions simultaneously
all of the above

⇒ The simplest mixer circuit for public address system uses
fixed resistances
variable resistances
inductances
capacitances

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ Switching systems
are limited to small data networks
require additional lines
are not used in data system
improve the efficiency of data transfer

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒

Assertion (A): Derivative control action cannot be used alone.

Reason (R): Derivative control action is effective only during transient periods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ While using Maxwell bridge, the Q factor of a coil is obtained as
1/ωCR
ωCR
ωC/R
R/ωC

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ For the system in the given figure, the gain margi
0
low
+ ∞
none of the above

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒ A voltmeter using thermocouples measures
rms value
peak value
average value
peak to peak value

⇒ Which of the following devices has a silicon dioxide layer?
NPN transistor
Tunnel diode
JFET
MOSFET

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ Average latency time of magnetic tape memory is of the order of
1 μ sec
1 msec
1 sec
1 minute

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W