Question is ⇒ VLF waves are used for communication system because, Options are ⇒ (A) of low power requirement, (B) they are least prone to distortion, (C) they penetrate the ionosphere easily, (D) the transmitting antennas are of convenient size, (E) , Leave your comments or Download question paper.

Question is ⇒ VLF waves are used for communication system because, Options are ⇒ (A) of low power requirement, (B) they are least prone to distortion, (C) they penetrate the ionosphere easily, (D) the transmitting antennas are of convenient size, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	VLF waves are used for communication system because
A.	of low power requirement [Wrong Answer]
B.	they are least prone to distortion [Wrong Answer]
C.	they penetrate the ionosphere easily [Correct Answer]
D.	the transmitting antennas are of convenient size [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For satellite communication, the frequency should be
equal to the critical frequency
more than the critical frequency
less than the critical frequency
none of these

⇒ A resistance strain gauge has a resistance of about
100 Ω
25 Ω
10 Ω
1 Ω

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒ In a piezoelectric crystal, application of a mechanical stress would produce
plastic deformation of the crystal
magnetic Dipoles in the crystal
electric polarization in the crystal
shift in the Fermi level

⇒ For the block diagram of the given figure, the equation describing system dynamic
(1 + RCs) Δθ₀(s) = Δθ_i(s) + R Δ H(s)
(1 + RCs) [ΔH(s)] = Δθ(s) - Δθ₀(s)
(1 + RCs) Δθ₀(s) = RΔ H(s) - Δ θ_i(s)
(1 + RCs) Δθ_i(s) = Δ H(s)[R] - Δθ₀(s)

⇒ RAM can be expanded to
increase word size
increase word number
either increase word size or increase word number
none of the above

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts

⇒ In which amplifier circuit is gate conductance negligible?
JFET amplifier
MOSFET amplifier
Both JFET and MOSFET amplifier
None of the above

⇒ For the circuit of the given figure, the output equatio
Y = ABCD
Y = AB + CD
Y = A + BCD
Y = ABC + D

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒ Radar reciever has high sensitivity and low noise figure
TRUE
FALSE

⇒ Which data transfer scheme is used when large block of data is to be transferred in a computer?
DMA
Programmed data transfer
Either (a) or (b)
Neither (a) nor (b)

⇒ A voltage wave containing 10% third harmonic is applied to a scries R-L circuit. The percentage third harmonic content in the current wave will be
more than 10%
10% or less than 10%
less than 10%
10% or more or less

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ 11011 in gray code = __________ .
10010₂
11111₂
11100₂
10001₂

⇒ The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts
23.7 mA
14.2 mA
13.7 mA
24.2 mA

⇒ In force voltage analogy, displacement is analogous to
current
voltage
charge
none of the above

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, X_L = 50 Ω, X_C is
10 Ω
14.14 Ω
7.07 Ω
50 Ω

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
- 2 V
2 V
- 4 V
4 V

⇒ The accuracy of measurement using CRO is about
± 0.5%
± 0.05 %
± 1%
± 3%

⇒ Which device uses Pneumatic fluid?
LED
LCD
VF display
None of these

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then array length will be
10 λ
100 λ
20 λ
5 λ

⇒ In TV scanning sequence of lines is
left to right
right to left
left to right for odd fields and right to left for even field
left to right for even fields and right to left for odd field

⇒ Two products are sold from a vending machine, which has two push buttons P₁ and P₂. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P₁ is pressed, '2' is displayed, signifying 'Rs.
3 NOT and 4 OR
2 NOT and 4 OR
1 NOT and 3 OR
2 NOT and 3 OR

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)