Question is ⇒ Vent plug is provided in each lead acid cell to, Options are ⇒ (A) pour water or electrolyte when needed., (B) check the electrolyte level., (C) allow escape out of gases during charging., (D) all of the above., (E) , Leave your comments or Download question paper.

Question is ⇒ Vent plug is provided in each lead acid cell to, Options are ⇒ (A) pour water or electrolyte when needed., (B) check the electrolyte level., (C) allow escape out of gases during charging., (D) all of the above., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Vent plug is provided in each lead acid cell to
A.	pour water or electrolyte when needed. [Wrong Answer]
B.	check the electrolyte level. [Wrong Answer]
C.	allow escape out of gases during charging. [Wrong Answer]
D.	all of the above. [Correct Answer]
View Answer 27 -11 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ During electroplating the weight of a substance deposited depends upon
shape of the article
quantity of electricity
room temperature
all of the above

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ Whithin the electric cell, the charge is transported by
Free electrons
Only positive ions
Only negative ions
Both positive and negative ions

⇒ The emf of primary cell depends upon the
physical dimensions of a cell.
nature of electrolyte.
nature of electrode.
both (b) and (c).

⇒ In comparison to constant current charging method, the constant voltage charging method of charging a lead acid battery has the advantage(s) of
increasing capacity of the battery.
reducing charging time.
avoiding of excessive gassing.
both (b) and (c).

⇒ Through an electrolyte an electric current is due to drift of
Free electrons
Positive and negative ions
Free electrons and holes
Protons

⇒ The arrangement of 12 cells, each of internal resistance 1.5 ω, to give maximum current in external load resistance of 2 ω will be
all 12 cells in series.
all 12 cells in parallel.
4 cells in series with 3 rows in parallel.
3 cells in series with 4 rows in parallel.

⇒ In lead acid batteries, sedimentation occurs due to
idleness foralongeiperiod.
overcharging at slow rate.
overcharging at high rate
slow charging at low rate.

⇒ Common impurity in a battery electrolyte is
dust particles.
iron.
lead crystals.
sodium chloride.

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ For keeping the lead acid battery terminals free from corrosion it is advisable to
keep electrolyte level low
apply petroleum jelly.
charge the battery at frequent intervals.

⇒ The current capacity of the charged secondary cell does not depend on
Rate of discharge
Temperature
Amount of active material
Rate of charging

⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
10 ω
15 ω
25 ω
40 ω

⇒ Battery charging equipment should be installed
in well ventilated, clean and dry place.
as near as practical to the battery under charge.
both (a) and (b).
wherever convenient.

⇒ Which of the following cells is more likely to be damaged due to short circuiting ?
Daniel cell
Dry Cell
Acid cell
Fuel cell

⇒ Which of the following substances on adding in electrolyte helps in producing bright finish?
Glycerine.
Dextrol.
Phenol.
Any of these.

⇒ The electric cell is a device to obtain
Electrons
Electric charge
Electric energy from chemical energy
Electric force

⇒ The capacity of a lead acid battery does not depend upon
charge rate.
discharge rate.
temperature.
density of electrolyte & quantity of active material.

⇒ If the specific gravity of the electrolyte in a lead acid cell increases beyond 1.23 there will be
loss of life.
loss of capacity.
increase in internal resistance.
corrosion of the grids of the plate.

⇒ In which of the following cells polarisation is the major defect ?
Voltanic cell
Lechlanche cell
Daniel cell
None of these

⇒ Pickling is
protection of surface from rusting.
a layer coating for preventing surface deterioration.
removal of scale, grease etc. from the surface.
none of the above.

⇒ In a lead acid battery, excessive formation of lead sulphate occurs due to
idleness of battery for a long time.
low level of electrolyte.
persistent undercharging.
all of the above.

⇒ Which of the following is not the name of a secondary cell ?
Acid cell
Alkali cell
Fuel cell
Storage cell

⇒ Capacity of a dry cell is
more when it supplies current continuously.
more when it supplies current intermittently.
not affected by the type of discharge.
none of the above.

⇒ Short circuiting of a cell results in
reduced gassing during charging.
abnormal high temperature.
low specific gravity of the electrolyte.
all of the above.

⇒ During charging and discharging of an Edison cell
electrolyte does not take part in chemical reaction.
emf remains the same.
corrosive fumes are produced.
nickel hydroxide remains unsplit.

⇒ In a lead acid battery, the level of the electrolyte should be
equal to that of the plates.
below the level of plates.
above the level of plates.
none of the above.

⇒ Charging of a sulphated battery at high rate causes
warping of plates.
boiling of electrolyte owing to gassing.
damage to separators, cell caps, covers and battery case due to excessive temperature.
all of the above.

⇒ In a battery, cover is placed over the elements and sealed at the top of the battery container. This is done in order to
exclude dirt and foreign matter from the electrolyte.
reduce evaporation of water from electrolyte.
both (a) and (b).
none of the above