Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Using the same flip flops |

A. | a synchronous flip flop can operate at higher frequency than ripple counter [Correct Answer] |

B. | a ripple counter can operate at higher frequency than synchronous counter [Wrong Answer] |

C. | both ripple and synchronous counter can operate at the same frequency [Wrong Answer] |

D. | can not determine [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Consider the following statements about ultrasonic flow meters:

- The measurement in insensitive to viscosity, pressure and temperature variations.
- It has bidirectional measuring capability and can be used for any pipe size.
- It has a relatively lower cost.
- It has good accuracy, fast response and wide frequency range.

1 only

1 and 2 only

1, 2 and 4

3 and 4 only

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is

a resistor

a capacitor

an inductor

a diode

⇒ A capacitor whose capacitance C

_{t}= C

_{0}(1- cos ω

*t*) is fed by a sinusoidal voltage

*v*= V

_{0}sin ω

*t*. The equation for current

*i*is

ω C

_{0}V

_{0}cos ω

*t*

ω C

_{0}V

_{0}sin ω

*t*

ω C

_{0}V

_{0}(cos ω

*t*- cos

^{2}ω

*t*)

none of the above

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in

a change in o.c voltage

a change in s.c current

decrease in resistance

increase in resistance

⇒

Match the following:

List I | List II | ||
---|---|---|---|

A. | Ratio of maximum energy stored to energy dissipated per cycle | 1. | Propagation constant |

B. | TEM mode is loss less medium | 2. | Cutoff frequency is zero |

C. | Ratio of frequency in radian to phase velocity of EM wave | 3. | Quality factor of cavity |

D. | TEM is the mode of lowest cutoff frequency | 4. | Cylindrical waveguide |

A-3, B-2, C-4, D-1

A-2, B-3, C-1, D-4

A-3, B-2, C-1, D-4

A-2, B-3, C-4, D-1

⇒ Consider the instructions

- MOV M, B
- OUT 4
- LDA X

Which of the above uses IO/W cycle?1 only

1 and 2 only

2 only

3 only

⇒ The DTFT of

*x*(

*n*) = δ(

*n*) will be

1

0

∞

not defined

⇒ The logic realized by the circuit shown in figure belo

F = A - C

F = A + C

F = B ⊙ C

F = B ⊕ C

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of

6

1

8

9

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi

5 V

10 V

15 V

30 V

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

- Its gain will increase
- Its stability will increase
- Its gain will decrease
- Its stability will decrease

1 and 2

2 and 3

3 and 4

1 and 4

⇒ In a minimum function

the degree of numerator is higher than that of denominator

the degree of numerator is lower than that of denominator

the degree of numerator and denominator are equal

the denominator is a constant

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.

TRUE

FALSE

⇒ In a shield helix

the spacing between adjacent turns is very large

the spacing between adjacent turns approaches zero

the spacing between adjacent turns approaches zero and wire thickness approaches zero

the spacing between adjacent turns is very large wire thickness approaches zero

⇒ In VHS format diameter of head drum is about

1 m

20 cm

6 cm

1 cm

⇒ Decimal number 9 in gray code =

1100

1101

110

1111

⇒ A P-N junction diode dynamic conductance is directly proportional to

the applied voltage

the temperature

its current

thermal voltage

⇒ Algebraic expression for

*z*-transform of

*x*[

*n*] is X[

*z*]... What is the algebraic expression of

*z*-transform of

*e*

^{jω0n}

*x*[

*n*]?

X(Z - Z

_{0})

X(

*e*

^{-jW0z})

X(

*e*

^{jω0z})

X(Z)

^{jω0z}

⇒ Which of the following is equivalent to

*x*?

x EX-OR 0

x EX-NOR 0

1 NOR x

x AND x

⇒ For TE or TM modes of propagation in bounded media, the phase velocity is

independent of frequency

is a linear function of frequency

is a non-linear function of frequency

can be frequency dependent or frequency independent on the source

⇒ In figure, V

_{C}is approximately equa

2 V

4.6 V

8 V

7.6 V

⇒ The minimum step size required for a Delta modulator operating at 36 samples/sec to track the signal (here

*u*(

*t*) is the unit step function)

*x*(

*t*) = 125

*t*(

*u*(

*t*) -

*u*(

*t*- 1)) + (250 - 125

*t*) (

*u*(

*t*- 1) -

*u*(

*t*- 2)) So that slope overload is avoided, would be

2

^{-10}

2

^{-8}

2

^{-6}

2

^{-4}

⇒ In a transistor the minimum and maximum values of β

_{dc}are 100 and 121. The proper value of β

_{dc}to be used to locate Q point is

100

121

110.5

110

⇒ The device 'one shot' has

two stable states

one stable state

either 1 or 2 stable states

no stable state

⇒ Which of the following expressions may be used to correctly describe the temperature (T) variation of the intrinsic carrier density (

*n*

_{i}) of a semiconductor?

*n*

_{i}(T) = (A/T) exp (- E

_{8}/kT

^{2})

*n*

_{i}(T) = A (- E

_{8}/2kT)

^{10}

*n*

_{i}(T) = A exp (- E

_{8}/2kT

^{2})

*n*

_{i}(T) = AT

^{3/2}exp (-E

_{8}/2kT)

⇒ The following circuit diagram resembl

logic 0

logic 1

*f*(A, B, C) = Σ

*m*(0, 1, 4, 6, 7)

none

⇒ The value of VSWR is taken as ∞ when the line is

short-circuited

open-circuited

terminated with full load

terminated with load equal to the characteristic impedance of the load

⇒ An air gap provided in the iron core of an inductor prevents

flux leakage

hysteresis loss

core saturation

heat generation

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be

0.05 MHz

1 MHz

2 MHz

4 MHz

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .

source, channel

channel, drain

source, drain

drain source