Question is ⇒ Under ordinary circumstances, impulse noise can be reduced in, Options are ⇒ (A) FM only, (B) AM only, (C) both AM and FM, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Under ordinary circumstances, impulse noise can be reduced in, Options are ⇒ (A) FM only, (B) AM only, (C) both AM and FM, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Under ordinary circumstances, impulse noise can be reduced in
A.	FM only [Correct Answer]
B.	AM only [Wrong Answer]
C.	both AM and FM [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If H(s) is positive real, 1/H(s)
is positive real
is not positive real
may or may not be positive real
must possess some other properties also if it is to be positive real

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ Q of a coil

increases with Q increasing frequency
varies linearly with frequency
increase with increasing frequency because R increases at high frequency
decrease after the peak frequency because R increases at H.F. the correct statements are

A, B
C, D
A, C
B, D

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ In a 5.6 ohms, ± 10% carbon composition resistor, the colour of the third strip from extreme left is
golden
silver
green
black

⇒ Some of MOS families are PMOS, NMOS, CMOS. The family dominating the LSI field where low power consumption is necessary is
NMOS
CMOS
PMOS
both NMOS and CMOS

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒

Match the following:

	List I		List II
A.	Anderson Bridge	1.	Low resistance
B.	Kelvin Bridge	2.	Medium resistance
C.	Schering Bridge	3.	Inductance
D.	Wheatstone Bridge	4.	Capacitance

A-4, B-2, C-3, D-1
A-3, B-2, C-4, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ The most important primary force of attraction in the formation of solids is
electromagnetic
electrostatic
quantum-electrostatic
quantum electromagnetic

⇒ In a hi-fi system the nonlinear distortion should be less than
0.1
0.05
0.02
0.01

⇒

Assertion (A): The regular or irregular stacking of atoms has importanteffect on properties of materials.

Reason (R): The arrangement of atoms in a given material can be studied using X-rays.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒ In digital circuits Schottky transistors are preferred over normal transistors because of their
lower propagation delay
lower power dissipation
higher propagation delay
higher power dissipation

⇒ A characteristic property of crystal is its periodicity of structure.
TRUE
FALSE

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be
0.416666666666667
0.208333333333333
3.185 A
1.414 A

⇒ If V_a = 10 ∠0, V_b = 10 ∠ -120° and V_c = 10 ∠ -240°, then V_a2 and V_a0 are
10 and 0 respectively
0 and 10 respectively
0 and 0
10 and 10

⇒ Which of the following equations satisfy Maxwell's equations?
E_x = E_y = 0, E_z = cos (y - ct)
E_x = E_y = 0, E_z = cos (y- ct)
F_y = cos (y - ct), E_x = E_z = 0
None of these

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ In a series RLC circuit for lower frequency power factor is ________
leading, Lagging
lagging, Leading
independent of frequency
same

⇒ In TE₁₀ mode of rectangular waveguide
there is one half sine wave variation along x direction and one along y direction
there is one half sine wave variation along y direction and one along x direction
there is one full sine wave variation along x direction and one along y direction
none of the above

⇒ A folded dipole antenna is conveniently connected to
shielded line
two wire line
coaxial line
flat ribbon type transmission line

⇒ The number of comparator circuits required to build a three-bit simultaneous A/D converter is
7
8
15
16

⇒ An RLC series circuit has R = 1 Ω, L = 1 H, C = 1 F. The damping ratio is
More than 1
1
0.5
Zero

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ The total number of leads in SUS, SBS and SCS respectively are
3, 3, 4,
3, 3, 3
2, 3, 3
3, 3, 5

⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be
2.2 A
less than 2.2 A
2.2 A or less than 2.2 A
2.2 A or less or more than 2.2 A

⇒ The maximum percent overshoot with maximum value of first overshoot as 3.5 V and steady state value as 2.575 V is
0.3592
0.2643
0.5761
0.1524