Question is ⇒ Two wattmeter method is suitable only for balanced loads., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Two wattmeter method is suitable only for balanced loads., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two wattmeter method is suitable only for balanced loads.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The capacitance of a cylindrical capacitor is directly proportional to its length.
TRUE
FALSE

⇒

Assertion (A): Points in the s plane at which function G(s) is not analytic are called singular, points.

Reason (R): Singular points at which the function G(s) or its derivative approach infinity are called poles.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ The following table gives some Laplace transforms and the functions

	f(t)	F(s)
1.	δ(t)	s
2.	u(t)	1/s
3.	tu(t)	2/s²
4.	t²u(t)	2s³

le>Of these the correctly matched pairs are
2 and 4
1 and 4
2 and 4
1 and 2

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒ The difference between phase and frequency modulation
is purely of academic interest
lies in the different definitions of the modulation index
lies in the poor audio response of phase modulation
is too great to make the two systems compatible

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor

⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?
linear for any value of b
linear if b > 0
linear if b < 0
non-linear

⇒ DC voltage of the order of a few mV can be accurately of measured by
PMMC voltmeters
moving iron voltmeter
null balancing potentiometer
electrostatic voltmeter

⇒ In 8085 the time required to add two 32 bit numbers is (if clock frequency is 5 MHz)
about 1 ns
about 1 μs
about 30 μs
about 100 μs

⇒ If J = 12 and X = 24.4 the result of the following FORTRAN 77 program will be 12, 144, 73.2
15.0, 144.0, 73.2
15.0, 144.0, 73
15. 144. 73

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒ Antenna radiation efficiency can be increased by
reducing radiation resistance of the system
increasing radiation resistance of the system
providing effective earthing
any of the above

⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R₁
condenser C₂
condenser C₁
inductor L

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is
proportional to length
proportional to square root of length
proportional to square of length
none of the above

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ Computer communication networks have
star configuration
tree configuration
loop/mesh configuration
All of the above

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒ In a backward wave oscillator the wave
travelling along the line winds itself back and forth
progresses only in forward direction
progresses only in backward direction
either (a) or (c)

⇒

Assertion (A): As the length of the resonant antenna is increased, the number of lobes increases and the direction of the major lobes is closer and closer to the direction of the diode.

Reason (R): As the length increases, the current distribution along the wire becomes more and more uniform.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
200 μC
400 μC
50 μC
25 μC

⇒ A signal f(t) = cos 10pt + 3 cos 4pt is instantaneously sampled. The maximum allowable value of sampling interval T_s in sec is
1 / 4 sec
1 / 8 sec
1 / 8p sec
1 / 10 sec

⇒ If the inputs to a 3 bit binary adder are 111₂ and 111₂, the output will be 110₂
TRUE
FALSE

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)