Question is ⇒ Two voltages are -5 V and -10 V. In positive logic, Options are ⇒ (A) -5 V is 1 and -10 V is 0, (B) -10 V is 1 and -5 V is 0, (C) -5 V is 1 in some circuits and 0 in others, (D) -10 V is 1 in some circuits and 0 in others, (E) , Leave your comments or Download question paper.

Question is ⇒ Two voltages are -5 V and -10 V. In positive logic, Options are ⇒ (A) -5 V is 1 and -10 V is 0, (B) -10 V is 1 and -5 V is 0, (C) -5 V is 1 in some circuits and 0 in others, (D) -10 V is 1 in some circuits and 0 in others, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two voltages are -5 V and -10 V. In positive logic
A.	-5 V is 1 and -10 V is 0 [Correct Answer]
B.	-10 V is 1 and -5 V is 0 [Wrong Answer]
C.	-5 V is 1 in some circuits and 0 in others [Wrong Answer]
D.	-10 V is 1 in some circuits and 0 in others [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ Ground wave propagation is useful for
microwave
medium wave
short wave
long distance

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the cut off frequency for dominant mode.
4 GHz
7.5 GHz
5 GHz
10 GHz

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ The purpose of using negative feedback in a op-amps is to
stabilize overall gain
increase output
stabilize overall gain and increase output
increase output and decrease input

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ Roughly the time required for microwave cooking as compared to conventional cooking is
about twice
about half
about 10 times
about one-tenth

⇒ Which multivibrator can be used as a clock timer?
Astable multivibrator
Bistable multivibrator
Any of the above
None of the above

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ The input impedance of short-circuited line of length l where l < λ/4
inductive
capacitive
resistive
none of the above

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ In the above case the total power in the modulated wave double sideband, suppressed carrier AM will be
112 W
400 W
415 W
512 W

⇒

Assertion (A): If an electron having charge e is revolving in an orbit of radius R and with angular velocity ω, the magnetic dipole moment of orbit is 0.5 eωR².

Reason (R): Orbital angular momentum and magnetic dipole moment are always equal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A ⊕ B ⊕ D
A ⊕ B ⊕ E
A ⊕ E
A ⊕ E

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ If the transfer function has zeros only on jω axis or in left half plane, it is a minimum phase function.
TRUE
FALSE

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒ A system has its two poles on the negative real axis and one pair of poles lies on jω axis. The system is
stable
unstable
limitedly stable
either (a) or (c)

⇒ In the expression b = 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?
2.1 / 1.2
1.2 * 3.1
2.1 / 1.2 * 3.1
3 / 7.1

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ In an ideal diode there is no breakdown, no __________ current, and no forward __________ drop.
reverse, voltage
forward, current
forward, voltage
reverse, current

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is
1.6 kbps
16 kbps
32 kbps
256 kbps

⇒ Which of the following meters cannot measure a.c. quantities?
Thermocouple
Hot wire
P.M.M.C.
Electrodynamometer.

⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.