Question is ⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is, Options are ⇒ (A) 70.7 V, (B) 80.4 V, (C) 92.4 V, (D) 100 V, (E) , Leave your comments or Download question paper.

Question is ⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is, Options are ⇒ (A) 70.7 V, (B) 80.4 V, (C) 92.4 V, (D) 100 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is
A.	70.7 V [Wrong Answer]
B.	80.4 V [Wrong Answer]
C.	92.4 V [Correct Answer]
D.	100 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)

⇒

Assertion (A): Logical group of instructions contains instructions for logic operations.

Reason (R): Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A typical value of insertion loss of SAW filter is
15 dB
2 dB
40 dB
60 dB

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ A meter has a resistance of 1 Ω and full scale deflection current of 1 mA. To convert into an ammeter of 1 A range, the shunt resistance should be
1000 Ω
1 Ω
0.01 Ω
0.001 Ω

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ The v-i characteristic shown in the given figure is
thermistor
photoconductor
varistor
none of the above

⇒ Consider the following statements:

A flip-flop is used to store 1-bit of information.
Race-around condition occurs in a J-K flip-flop when both the inputs are 1.
Master-slave configuration is used in flip-flops to store 2-bits of information
A transparent latch consists of a D-type flip-flop.

Which of the above statements is/are correct?
1 only
1, 3 and 4
1, 2 and 4
2 and 3 only

⇒ In classical analogue, torque is analogous to
current
voltage
charge
voltage gradient

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain
higher sensitivity
better impedance matching
compensation for signal wire resistance
reduction in power consumption

⇒ In any network of linear impedances the current flowing at any point equal to algebric sum of currents caused to flow at that point by each of the emf taken separately with all other emfs reduced to zero. The statement represents.
KCL
Norton's theorem
Thevenin's theorem
Superposition theorem

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒

Assertion (A): In state space analysis, capacitors are taken to be in tree.

Reason (R): State variable analysis is very suitable for computer solution.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒

Assertion (A): In register indirect addressing mode of 8085, the address of operand is in the specified register.

Reason (R): An example of register indirect addressing mode is MOV, A, M..

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An ideal Op-amp is an ideal
voltage controlled current source
voltage controlled voltage source
current controlled current source
current controlled voltage source

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The power to the portable unit of a cordless telephone is provided by
pencil cells
dry cells
rechargeable cells
AC mains

⇒ Magnetic flux can be measured by
capacitive pick up
inductive pick up
resistive pick up
hall effect pick up

⇒ Which of the following devices has metal-silicon junction?
General purpose power diode
Schottky diode
SCR
MOSFET

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ Which of the following material has nearly zero temperature-coefficient of resistance?
Carbon
Porcelain
Copper
Manganin

⇒

Assertion (A): For a given system only one of the static error constants is finite and significant.

Reason (R): If finite static error constant is large, the loop gain becomes smaller as ω approaches zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A loudspeaker transformer has a turns ratio of 20 : 1. The speaker impedance is 20Ω. Primary impedance of transformer is
10 K
8 K
20 K
0.5 K