Question is ⇒ Two thyristor of same rating and same specifications, Options are ⇒ (A) will have equal turn on and turn off periods, (B) will have equal turn on but unequal turn off periods, (C) may have equal or unequal turn on and turn off periods, (D) will have unequal turn on and turn off periods, (E) , Leave your comments or Download question paper.

Question is ⇒ Two thyristor of same rating and same specifications, Options are ⇒ (A) will have equal turn on and turn off periods, (B) will have equal turn on but unequal turn off periods, (C) may have equal or unequal turn on and turn off periods, (D) will have unequal turn on and turn off periods, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two thyristor of same rating and same specifications
A.	will have equal turn on and turn off periods [Wrong Answer]
B.	will have equal turn on but unequal turn off periods [Wrong Answer]
C.	may have equal or unequal turn on and turn off periods [Correct Answer]
D.	will have unequal turn on and turn off periods [Wrong Answer]
View Answer 1 -6 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A good algorithm should be fast, require minimal computer memory and time.

Reason (R): Many times an algorithm is prepared in the form of a flow chart.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following elements act as donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Indium

Select the correct answer using the codes given below:
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
1, 4, 5

⇒ The conductivity of an intrinsic semiconductor is
generally less than that of a doped semiconductor
given by σ₁ = en_i (μ_n - μ_p)
given by σ₁ = en_i (μ_p + μ_n)
given by σ₁ = n_i (μ_n + μ_p)

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒

Assertion (A): An unbiased p-n junction develops a built-in potential at the junction with the n-side positive and the p-side negative.

Reason (R): The p-n junction behaves as a battery and supplies current to a resistance connected across its terminals.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ A wave E_m cos (bx - ωt) is a backward wave.
TRUE
FALSE

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ Photo electric emission can occur only if the frequency of light is more than threshold frequency.
TRUE
FALSE

⇒ Sulphur hexafluoride is used in
transformers
generators
relays
circuit breakers

⇒ For an I/p of V_s = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave
clipper, sine wave clipped at -2 V
clamper, sine wave clamped at -2 V
clamper, sine wave clamped at 0 volts
clipper, sine wave clipped at 2 V

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ If transmitted power is 75 kW, the field strength at 30 km distance will be about
10 V/m
1 V/m
50 mV/m
2 mV/m

⇒ As B is increased from zero to about 2T, μ_r, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same

⇒ What will be maximum input that can be converted for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9 V
9.45
10 V
8 V

⇒ If a number of odd functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease

⇒ Consider the following:

Oscillator
Emitter follower
Cascaded amplifier
Power amplifier

Where of these use feedback amplifiers?
1 and 2
1 and 3
2 and 4
3 and 4

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ At the peak of negative half cycle in fi
diode A is forward biased and diode B is reverse biased
both diodes are reverse biased
both diodes are forward biased
diode A is reverse biased and diode B is forward biased

⇒ In a multicavity klystron amplifier the signal to be amplified develops an ac voltage of signal frequency across the gap in buncher cavity
TRUE
FALSE

⇒ It is desired to evaluate the expression F = B * COS (Y) + C * SQR (COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
F = B * COS (Y) + C * SQR [COS (Y)] + A * COS (Y) * SQR [COS (Y)]
F = B * COS (Y) + C * COS(Y) * COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
X = COS(Y)



⇒ DC tachogenerator can be used in
speed control system
position control system
both (a) and (b)
neither (a) nor (b)

⇒ The charge per proton is
1.6 x 10^-19 C
2.6 x 10^-19 C
0.6 x 10^-19 C
1.6 x 10^-13 C

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE



⇒ Two impedances 10 - j 10 and 10 + j 10 are connected in parallel. Their combined impedance is
5 + j5
5 - j5
10 + j0
20 - j10

⇒ Match the following:
 List I  List II 
A. Very low response at very high frequencies 1. Low-pass system
B. Over shoot 2. Velocity damping
C. Synchro-control transformer output 3. Natural frequency
  4. Phase-sensitive modulation
  5. Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	



    
	StudySite.org is world's best online study provider, Copyright © 2023 by 
StudySite.org All Rights Reserved