Question is ⇒ Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then, Options are ⇒ (A) transients in circuit 2 will decay faster, (B) transients in circuit 1 will decay faster, (C) transients in both circuits will decay at the same rate, (D) transients in any one may decay faster than in the other, (E) , Leave your comments or Download question paper.

Question is ⇒ Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then, Options are ⇒ (A) transients in circuit 2 will decay faster, (B) transients in circuit 1 will decay faster, (C) transients in both circuits will decay at the same rate, (D) transients in any one may decay faster than in the other, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then
A.	transients in circuit 2 will decay faster [Wrong Answer]
B.	transients in circuit 1 will decay faster [Correct Answer]
C.	transients in both circuits will decay at the same rate [Wrong Answer]
D.	transients in any one may decay faster than in the other [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A tachometer has a sensitivity of 4 V/1000 rpm. Express the gain constant of the tachometer in the units volts/(rad/sec).
0.0489
0.0381
2
none of these

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What must be the minimum gain of the oscillator to provide oscillations?
40
60
100
130

⇒ Consider the following statements about ultrasonic flow meters:

The measurement in insensitive to viscosity, pressure and temperature variations.
It has bidirectional measuring capability and can be used for any pipe size.
It has a relatively lower cost.
It has good accuracy, fast response and wide frequency range.

Which of the above statements is/are correct?
1 only
1 and 2 only
1, 2 and 4
3 and 4 only

⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions
flip-flop
schmitt trigger
monostable multivibrator
astable multivibrator

⇒ A carry look ahead adder is frequently used for addition because
it costs less
it is faster
it is more accurate
is uses fewer gates

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ The sensor generally used in incremental optical encoder is
LED
LCD
photodiode
either (a) or (b)

⇒ Johnson noise is
white for all Practical application
always white
depends on temperature
never white

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ When cells having different emfs are connected in parallel, a circulating current flows.
TRUE
FALSE

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ A heater is rated at 230 V, 5 A AC. Then
both the current and voltage are peak values
both the current and voltage are rms values
the current is peak value and voltage is rms value
the current is rms value and voltage is peak value

⇒ The transmitting antennas for lower frequencies (below 500 kHz) are generally
vertical grounded wire type
horizontal suspended wire type
parabolic reflector type
any of the above

⇒ For a bipolar transistor, avalanche multiplication factor depends on __________ .
V_CE
V_CB
V_BE
none of these

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ Two numbers in excess-3 code are added and the result is less than 8. To get equivalent binary
0011 is subtracted
0011 is added
0110 is subtracted
0110 is added

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒ A VF display operates on the principle of a vacuum diode.
TRUE
FALSE

⇒ Which is known as flash converter?
Weighted resistor D/A converter
Parallel A/D converter
Stair step A/D converter
Up-down counter type A/D converter

⇒ In following figure find V_DSQ by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
4 V
- 6 V
- 10 V
6 V

⇒ A system has its two poles on the negative real axis and one pair of poles lies on jω axis. The system is
stable
unstable
limitedly stable
either (a) or (c)

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒ Transistor are free from which type of noise?
Resistance noise
Partition noise
Flicker noise
Shot noise

⇒ If two networks are connected in parallel then equivalent y parameter of both is
[y] = [y_a] [y_b]
[y] = [y_a] + [y_b]
[y] = [y_a]/[y_b]
none

⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode