Question is ⇒ Two resistances R1 = 18.7 Ω. and R2 = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is, Options are ⇒ (A) 22.324 Ω, (B) 22.32 Ω, (C) 22.3 Ω, (D) 22 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Two resistances R1 = 18.7 Ω. and R2 = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is, Options are ⇒ (A) 22.324 Ω, (B) 22.32 Ω, (C) 22.3 Ω, (D) 22 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
A.	22.324 Ω [Wrong Answer]
B.	22.32 Ω [Wrong Answer]
C.	22.3 Ω [Correct Answer]
D.	22 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance

⇒

Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.

Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒

Assertion (A): The rms value of v = 1 + sin ωt is 1.5

Reason (R): If i = I₀ + I_1m sin ω₁t + I_3m sin 3ω₁t,
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE

⇒ In paramagnetic materials
permanent magnetic dipoles exist but the interaction between neighbouring dipoles is negligible
permanent magnetic dipole do not exist
permanent magnetic dipoles exist and the interaction between neighbouring dipoles is very strong
permanent magnetic dipole moment may or may not exist

⇒ Find value
1A
0A
0.45 A
None of these

⇒ In its lowest state, the electron is bound to the field of proton by an energy equal to
100.5 eV
51.2 eV
13.6 eV
0.2 eV

⇒ The antenna most commonly used for TV broadcasting in the UHF band is
turnstile antenna
dipole antenna
yagi antenna
rhombic antenna

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ An RL admittance function can also be realized as
RC admittance function
RC impedance function
LC admittance function
LC impedance function

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒ Using 4-bit numbers (n = 4) if k = (0011)₂ how is k expressed in 2's complement.
(1011)₂
(1101)₂
(1100)₂
(0101)₂

⇒ In cell communication
carrier frequency change
carrier frequency constant
depend upon location
depend upon geographical area

⇒ For the transport lag G(jω) = e^-jωT, the magnitude is always equal to
0
1
10
0.5

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ Which of the following is type declaration statement in C?
int bar
s = s + 1
king = horse + 1
prin = prin * prin

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒ In monolithic ICs, all the components are fabricated by
diffusion process
oxidation
evaporation
none

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode

⇒ The reason for glitches on the outputs of decoding gates on a synchronous counter is
FFs changing states together
FFs changing states one at a time
AND gates not functioning properly
none of the above

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ The beam of a radar should be
very narrow
very wide
neither too narrow nor very wide
either (b) or (c)

⇒ In satellite communication, highly directional antennas are used to
direct the spot beam to a particular region of space on Earth
strengthen the beam to overcome the cosmic noise
make corrections in change of polarisation of the beam
select a particular channel in transmission and reception

⇒ When load is coupled to class A amplifier through transformer, efficiency decreases.
TRUE
FALSE

⇒ When a plane wave is incident normally from dielectric '1' (μ₀, ε₁) onto dielectric '2' (μ₀, ε₂) the electric field of the transmitted wave is 2 times the electric field of the reflected wave. The ratio ε₂/ε₁ is
0.5
1
2
4