Question is ⇒ Two products are sold from a vending machine, which has two push buttons P1 and P2. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P1 is pressed, '2' is displayed, signifying 'Rs., Options are ⇒ (A) 3 NOT and 4 OR, (B) 2 NOT and 4 OR, (C) 1 NOT and 3 OR, (D) 2 NOT and 3 OR, (E) , Leave your comments or Download question paper.

Question is ⇒ Two products are sold from a vending machine, which has two push buttons P1 and P2. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P1 is pressed, '2' is displayed, signifying 'Rs., Options are ⇒ (A) 3 NOT and 4 OR, (B) 2 NOT and 4 OR, (C) 1 NOT and 3 OR, (D) 2 NOT and 3 OR, (E) , Leave your comments or Download question paper. 1 is pressed, '2' is displayed, signifying 'Rs., Options are ⇒ (A) 3 NOT and 4 OR, (B) 2 NOT and 4 OR, (C) 1 NOT and 3 OR, (D) 2 NOT and 3 OR, (E) , Leave your comments or Download question paper. '/> 1 is pressed, '2' is displayed, signifying 'Rs., Options are ⇒ (A) 3 NOT and 4 OR, (B) 2 NOT and 4 OR, (C) 1 NOT and 3 OR, (D) 2 NOT and 3 OR, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	Two products are sold from a vending machine, which has two push buttons P₁ and P₂. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P₁ is pressed, '2' is displayed, signifying 'Rs.
A.	3 NOT and 4 OR [Wrong Answer]
B.	2 NOT and 4 OR [Wrong Answer]
C.	1 NOT and 3 OR [Wrong Answer]
D.	2 NOT and 3 OR [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The chip 8254 is a 40 pin programmable interval timer. The number of its independent 16 bit counters is
2
3
4
5

⇒ The scale of dynamometer wattmeter is non linear.
TRUE
FALSE

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ Decimal 45.15 when converted into 9's complement will become
54.84
45.48
48.54
45.84

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ In the spectrum of a FM wave
the carrier frequency cannot disappear
the carrier frequency disappears when the modulation index is large
the amplitude of any sideband depends on the modulation index
the total number of sidebands depends on the modulation index

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ In a series R-L-C circuit, the voltage across inductance will be maximum
at resonance frequency
just before resonant frequency
just after resonant frequency
none of the above

⇒ Almost all resistors are made in a monolithic integrated circuit
during the entire diffusion
while growing the epitaxial layer
during the base diffusion
during the collector diffusion

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16

⇒ In a TWT the amplitude of resultant wave travelling down the helix remains constant
TRUE
FALSE

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ Which of the following subtraction operations do not result in F₁₆?

(BA)₁₆ - (AB)_{161 and 2
1 and 3
2 and 3
1, 2 and 3}

⇒ A tape recorder and deck are entirely similar.
TRUE
FALSE

⇒ For the network in figure, the correct loop equation for loop
-I₁ + 4I₂ + 11I₃ = 0
I₁ + 4I₂ + 11I₃ = 0
-I₁ - 4I₂ + 11I₃ = 0
I₁ - 4I₂ + 6I₃ = 0

⇒ In a series RLC high Q circuit the current peaks at a frequency.
equal to the resonant frequency
greater than the resonant frequency
less than the resonant frequency
none

⇒ Which one is digital modulation technique?
AM
PAM
PCM
None

⇒ A 4 line to 16 line decoder has
16 inputs and 4 outputs
4 inputs and 16 outputs
either (a) or (b)
neither (a) nor (b)

⇒ In a single-stage RC coupled common emitter amplifier, the phase shift at the lower 3 dB frequency is
zero
135°
180°
225°

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ Consider the following ON GO TO statement in Ba
10, 20, 30, 20 respectively
10, 20, 20, 30 respectively
20, 30, 20, 10 respectively
10, 30, 20, 20 respectively

⇒ Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network
the same Thevenin's circuit can be used
the same Thevenin's circuit with some modification can be used
it is necessary to find new Thevenin's circuit
either (b) or (c)

⇒ When a dc chopper feeds an RLE load, the load current, during steady state operation
remains constant
varies between maximum and minimum values
may remain constant or vary
is constant if R is constant

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒
Assertion (A): In 8085, P flag is for parity checking.
Reason (R): If the result of ALU has even parity, P flag is set and if the result has odd parity, P flag is reset.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ For the network shown below, determine f_Hi and f_HO, if, r₀ = ∞, C_be = 36 Pf, C_bc = 4 Pf, C_ce = 1 Pf, C_wo = 8 Pf, C_wi = 6 Pf<
738.24 KHz, 8.6 MHz
781.2 KHz, 10.6 MHz
838.32 KHz, 9.2 MHz
938.24 KHz, 8.2 MHz

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ Power gain of an antenna in a given direction is the ratio of
average power to maximum power
radiation intensity in that direction to the total input radiated power
radiation intensity in that direction to the average radiated power
none of the above

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math