Question is ⇒ Two port Z parameter not exist for the circuit if, Options are ⇒ (A) Δz = 0, (B) Δz, (C) Δz = 1, (D) always exist, (E) , Leave your comments or Download question paper.

Question is ⇒ Two port Z parameter not exist for the circuit if, Options are ⇒ (A) Δz = 0, (B) Δz, (C) Δz = 1, (D) always exist, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two port Z parameter not exist for the circuit if
A.	Δz = 0 [Correct Answer]
B.	Δz [Wrong Answer]
C.	Δz = 1 [Wrong Answer]
D.	always exist [Wrong Answer]
View Answer 1 -6 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ A 0.5 μF capacitor is connected across a 10 V battery. After a long time, the circuit current and voltage across capacitor will be
0.5 A and 0 V
0 A and 10 V
20 A and 5 V
0.05 A and 5 V

⇒ Out of the three transforms viz. Z-transform, Laplace transform and Fourier transform
all three are used in continuous time domain
all three are used in both continuous time domain and discrete time domain
Z transform is used in continuous time domain while Laplace and Fourier transforms are used in discrete time domain
Z transform is used is discrete time domain while Laplace and Fourier transforms are used in continuous time domain

⇒ In a stereo tape recorder the speed of the tape is
38 m/s
19 m/s
9.5 m/s
4.75 m/s

⇒ The value of a in a transistor
is always equal to 1
is less than 1 but more than 0.9
is about 0.4
is about 0.1

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ A 3 bit binary adder should use
3 full adders
2 full adders and 1 half adder
1 full adder and 2 half adders
3 half adders

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ In Quine-Mclusky method of Boolean function reduction; __________ , are treated as __________ and therefore discrepancies may occur in the final solution, therefore this method is not applicable to the functions with __________ .
zeros, don't care conditions, zeros
one's, don't care conditions, one's
don't care conditions, zeros, don't care conditions
don't care conditions, don't care conditions, don't care conditions

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ When a thyristor is conducting, the voltage drop across it
is absolutely constant
decreases with increase in load current
increases slightly with increase in load current
none of the above

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ A voltmeter using thermocouples measures
rms value
peak value
average value
peak to peak value

⇒ Transition capacitance is associated with __________ and depletion capacitance is associated with __________ diodes.
reverse bias and forward bias
forward bias and reverse bias
reverse bias and reverse bias
forward bias and forward bias

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE₁₁ mode. The minimum operating frequency is
6.25 GHz
6.0 GHz
5.0 GHz
3.75 GHz

⇒ The knee voltages in silicon and germanium diodes respectively are
0.3 V and 0.7 V
0.7 V and 0.3 V
0.7 V each
0.3 V each

⇒ A single phase half bridge inverter required to feed R-L loads needs
2 thyristors
4 thyristors
2 thyristors and two diodes
4 thyristors and 4 diodes

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ Which of the following is active transducer?
Photoelectric
Photovoltaic
Photoconductive
Photoemissive

⇒ Which of the following binary numbers is equivalent to decimal 10?
1000
1100
1010
1001

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V

⇒ A circular waveguide carries TE₁₁ mode whole radial electric field is give
10 cm
3 p cm
2 p cm
8 cm

⇒ A 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V. It meets standard linearity then resolution in percent and volts.
3% 7 V
6.4 V, 2%
0.1%, 1.57 V
1.57%, 0.1 V

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒ A ripple counter has 4 bits and uses flip flops with propagation delay time of 25 ns. The maximum possible time for change of state will be
25 ns
50 ns
75 ns
100 ns

⇒ Two rectangular waveforms of duration t₁ and t₂ seconds are convolved. What is the shape of the resulting waveform?
Triangular
Rectangular
Trapezoidal
Semi-circular

⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
60 and 15
15 and 60
6 and 1.5
1.5 and 6