Question is ⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is, Options are ⇒ (A) 0.3 V, (B) 0.5 V, (C) 1 V, (D) 1.5 V, (E) , Leave your comments or Download question paper.

Question is ⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is, Options are ⇒ (A) 0.3 V, (B) 0.5 V, (C) 1 V, (D) 1.5 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
A.	0.3 V [Correct Answer]
B.	0.5 V [Wrong Answer]
C.	1 V [Wrong Answer]
D.	1.5 V [Wrong Answer]
View Answer 5 -6 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Find equivalent capacitance if each capacitance is
5/12 F
12/5 F
6/5 F
5/6 F

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ In metals, the flow of current is due to
electrons
ions
holes
electrons and ions

⇒ During amplitude modulation, the phase angle of the modulating voltage changes by
0°
45°
90°
180°

⇒ Find resistance R_B to bring transistor to threshold of saturation (V_CB = 0), V_BE = 0.7 V, a =
1.5 KΩ
15 KΩ
10 KΩ
1 KΩ

⇒ The contents of the program counter after the call operation point to the first instruction on
stack
subroutine
either of the above
none of the above

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ A satellite link uses different frequencies for receiving and transmitting in order to
avoid interference from terrestrial microwave links
avoid interference between its powerful transmitted signal and weak in coming signal
minimise free-space losses
maximise antenna gain

⇒ In a current mirror
the i - v curve of compensating diode is similar to collector curve of transistor
the i - v curve of compensating diode is similar to transconductance curve of transistor
either (a) or (b)
neither (a) nor (b)

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒ Covalent bond energy in Germanium is approximately
3.8 eV
4.7 eV
7.4 eV
12.5 eV

⇒ In a microwave power measurement using bolometer, the principle of working is variation of
inductance with absorption of power
resistance with absorption of power
capacitance with absorption of power
cavity dimension with heat generated by power

⇒ Which of the following is true about an impulse voltage?
It is a unidirectional voltage
Chopped impulse flashover does not occur
Time taken to rise is equal to time taken to fall
RMS value is always less than 50% of average value

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ Consider the following: Energy storage capability of basic passive elements is due to the fact that

resistance dissipates energy
capacitance stores energy
inductance dissipates energy

Which of the above is/are correct?
1, 2, and 3
1 and 3
3 only
1 and 2

⇒ In the circuit of figure, the power consumed in resistance R is measured when one source is acting at one time. These values are 18 W, 50 W and 98 W. When all source act together the maximum and minimum power ca
98 W and 18 W
166 W and 18 W
450 W and 2 W
166 W and 2 W

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ Some multiplexing arrangements for telephone system are

Space multiplexing
Time division multiplexing
Frequency division multiplexing

Which of the above allow transmission of many independent signals over a single channel?
1 only
2 and 3 only
1, 2, 3
1 and 3 only

⇒

Match the following:

	List I		List II
A.	Reactance theorem	1.	Foster
B.	Driving point impedance	2.	Bartlett
C.	Continued fraction expansion	3.	Cauer
D.	Bisection Theorem	4.	Positive real function

A-1, B-4, C-3, D-2
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ The wavelength of light emitted by GaAs laser is 8670 x 10^-10 m. If h = 6.626 x 10^-34 Js, velocity of light = 3 x 10⁸ m/s and eV = 1.602 x 10^-19 J, the energy gap in GaAs is
0.18 eV
0.7 eV
1.43 eV
2.39 eV

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃

⇒ In 8085 microprocessor based system running at 3 MHz clock frequency what should be the minimum pulse width of the INTR signal, so that it is recognized successfully?
0.33 μs
0.666 μs
5.8 μs
none of these

⇒ The number of branches of root locus plot is equal to
the number of roots of characteristic equation
double the number of roots of characteristic equation
the number of roots of characteristic equation minus one
the number of roots of characteristic equation plus one

⇒ In figure, the current supplied by battery at t = 0.5s1.1 A
1.9 A
0
1.632 A

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ A 6 MHz channel is used by a digital signalling system initializing four-level signals. The maximum possible transmission rate is
6M bands/s
12M bands/s
6 M bits/s
12M bits/s

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math