Question is ⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is, Options are ⇒ (A) 1.67, (B) 0.6, (C) 0.36, (D) 0.216, (E) , Leave your comments or Download question paper.

Question is ⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is, Options are ⇒ (A) 1.67, (B) 0.6, (C) 0.36, (D) 0.216, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is
A.	1.67 [Wrong Answer]
B.	0.6 [Correct Answer]
C.	0.36 [Wrong Answer]
D.	0.216 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of figur
positive clipper
negative clipper
combination clipper
either (a) or (b)

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The integral of a unit impulse is
a unit step function
a ramp function of slope 1
a pulse function of magnitude 1
none of the above

⇒ For a wave v = V _1m sin (ωt + θ₁ ) - V_3m sin (3ωt + θ₃), the rms value is (0.5 V²_1m + 0.5 V²_3m)^0.5
TRUE
FALSE

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ The parameter h₁₁ for CB circuit is higher than that for CE circuit.
TRUE
FALSE

⇒ To couple a coaxial line to a parallel to wire line it is best to use a
slotted line
balun
directional coupler
quarter wave transformer

⇒ The stationary process has
all the statistical Properties dependent on time.
all the statistical Properties independent of time.
aime average is equal to ensemble average.
zero variance.

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ The resolution of a 12-bit D/A converter using a binary ladder with + 10V as the full scale output will be
2.44 mV
3.50 mV
4.32 mV
5.12 mV

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ For the minterm designation Y = ∑ m (1, 3, 5, 7) the complete expression is
Y = A BC + A B C
Y = A B C + A B C + ABC + A BC
Y = A B C + A B C + ABC + A BC
Y = A B C + ABC + A BC + A BC

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Evanescent wave	1.	Pattern multiplication
B.	Skip distance	2.	Mismatched transmission line
C.	Return loss	3.	Propagation in lossy medium
D.	Antenna array	4.	Short wave propagation
		5.	Propagation below cut-off

A-5, B-2, C-4, D-3
A-2, B-4, C-1, D-5
A-5, B-4, C-2, D-1
A-1, B-3, C-4, D-5

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ Distilled water at 25°C is characterized by σ = 1.7 x 10^-4 mho/m and ε = 78 ε₀ at a frequency of 3 GHz. Its loss tangent is (ε = 10^-9/36p F/m)
1.3 x 10^-5
1.3 x 10^-3
1.7 x 10^-4/78
1.7 x l0^-4/78ε₀

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ Pico-farad is equal to
10^-6 farad
10^-12 farad
10^-3 farad
10^-9 farad

⇒ Which of the following amplifiers has highest output impedance?
CE
CB
CC
Push pull

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ In intrinsic semiconductor magnitude of free electron and hole concentrations are equal.
TRUE
FALSE

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ Which one of the following is loaded in the main memory by the bootstrap loader?
System data
User program
BIOS
Part of DOS

⇒ Transport lag usually exists in
thermal systems
hydraulic systems and thermal systems
pneumatic systems
thermal, hydraulic and pneumatic systems

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors