Question is ⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be., Options are ⇒ (A) 55.56 and 44.44 A respectively, (B) 44.44 A and 55.56 A respectively, (C) 60 A and 40 A respectively, (D) 40 A and 60 A respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be., Options are ⇒ (A) 55.56 and 44.44 A respectively, (B) 44.44 A and 55.56 A respectively, (C) 60 A and 40 A respectively, (D) 40 A and 60 A respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
A.	55.56 and 44.44 A respectively [Correct Answer]
B.	44.44 A and 55.56 A respectively [Wrong Answer]
C.	60 A and 40 A respectively [Wrong Answer]
D.	40 A and 60 A respectively [Wrong Answer]
View Answer 3 -8 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The radiation resistance of a circular loop of one turn is 0.01 ohm. For 5 turn loop the radiation resistance is
0.002 Ω
0.01 Ω
0.05 Ω
0.25 Ω

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ Assuming that k is an integer what would the result of following expression
8
7
7.5
zero

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ The sensitivity of a voltmeter using 0-5 mA meter movement is
50 Ω/V
100 Ω/V
200 Ω/V
500 Ω/V

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ The z-transform of sequence x[n] = δ(n) is
1
∞
0
z

⇒ Which of the following polynomials is not Hurwitz?
P₁ = s⁸ + 2s⁶ + 4s⁴
P₂ = s⁶ - 3s⁴ + 2s² + 1
P₃ = s⁴ + 3s³ + 3s² + 2s + 1
P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒ The number FF in hexadecimal system is equivalent to number __________ in decimal system.
256
255
240
239

⇒ A telephone exchange has 9000 subscribers. If the number of calls originating at peak time is 10, 000 in one hour, the calling rate is
0.9
43017
0.81
0.1

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ A 4 bit ripple counter starts in 0000 state. When the counter reads 0010 the number of clock pulses which have occurred is
2
18
2 or 18
2 or 18 or 34

⇒ In a class C operation V_CC = 40 V, R_L = 50 Ω. The maximum load power can be
64 W
32 W
16 W
8 W

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ Which of the following circuits come under the class of sequential logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ In a stop-and-wait ARQ system, the transmitting terminal
waits for positive or negative acknowled-gement from the receiving terminal after sending a block
sends another block if positive acknowledge is received through ACK character
resends the previous block if negative acknowledgement is received through a NAK character
does not wait for acknowledgement after sending a block

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ Integral control action
removes offset
may lead to oscillatory response
both (a) and (b)
neither (a) nor (b)

⇒ If the peak value of output of a half wave rectifier is 100 V, the rms value is
100 V
50 V
70.7 V
35.35 V

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒

Assertion (A): Thermocouple instruments can be used for ac only.

Reason (R): Thermocouple instrument has a non linear scale.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In digital TV digital imaging standard comprises
six profiles and four levels
four levels and six profiles
six profiles and six levels
four profiles and four levels