Question is ⇒ TV receivers use flyback switched mode power supply because, Options are ⇒ (A) it can supply many voltage outputs, (B) it does not require a filter choke and is cheap, (C) it has very good regulation at all loads, (D) both (a) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ TV receivers use flyback switched mode power supply because, Options are ⇒ (A) it can supply many voltage outputs, (B) it does not require a filter choke and is cheap, (C) it has very good regulation at all loads, (D) both (a) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	TV receivers use flyback switched mode power supply because
A.	it can supply many voltage outputs [Wrong Answer]
B.	it does not require a filter choke and is cheap [Correct Answer]
C.	it has very good regulation at all loads [Wrong Answer]
D.	both (a) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
33.9 Hz
27.1 Hz
13.6 Hz
16.9 Hz

⇒

Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W

Reason (R): Heat sinks of thyristors are generally made of aluminium.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Figure represen
Diode rectifier
Schottky diode
Varistor
None of the above

⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt²
volt/sec
volt-sec

⇒ What is the necessary a.c. input power from the transformer secondary used in a half wave rectifier to deliver 500 W of d.c. power to the load?
1232 W
848 W
616 W
308 W

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ Find R_TH across the terminals A a
52.28 Ω
58.28 Ω
52.82 Ω
58.82 Ω

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ In force voltage analogy the quantity analogous to spring constant K is
R
C
L
1/C

⇒ By the use of which of the following the PPM can be converted to PWM?
A stable multivibrator
Integrator
Monostable multivibrator
Bistable Multivibrator

⇒ Which of the following is not treated as hexadecimal constant by assembler in 8085?
64 H
5 AFH
AFH
OCFH

⇒ Iron has a body centred cubic structure.
TRUE
FALSE

⇒ The advantage of Marconi antenna over the ungrounded antenna is that
only one fourth of the height is required as compared to undergrounded antenna
one-half of the height is required as compared to undergrounded antenna
no capacitance required
none of the above

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ The circuit in figur
Cauer I form
Foster I form
Cauer II form
Foster II form

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ Decade counter has 4 flip flops and skips states 10 to 15.
TRUE
FALSE

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ In a series resonant circuit, the resonant frequency is
geometric mean of half power frequencies
arithmetic mean of half power frequencies
difference of half power frequencies
none of the above

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ A twisted ring counter consisting of 4 FF will have
4 states
8 states
2⁴ states
None of the above

⇒ The attenuation characteristics of a loaded line is similar to that of
low pass filter
high pass filter
band pass filter
band stop filter

⇒ A Marconi antenna
is a grounded antenna with a length equal to λ/4
is an ungrounded antenna with a length equal to λ/4
has a length equal to 1
has a length equal to λ/2

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode