Question is ⇒ Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time), Options are ⇒ (A) ts - tr, (B) ts - tf, (C) td + tr, (D) 2tr, (E) , Leave your comments or Download question paper.

Question is ⇒ Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time), Options are ⇒ (A) ts - tr, (B) ts - tf, (C) td + tr, (D) 2tr, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
A.	t_s - t_r [Wrong Answer]
B.	t_s - t_f [Wrong Answer]
C.	t_d + t_r [Correct Answer]
D.	2t_r [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300 K will be (in m²/s)
0.4
0.16
0.04
0.01

⇒ To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
surge resistor
surge inductor
surge capacitor
both (a) and (b)

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ The advantage of using dual slope ADC in digital voltmeter is that
its conversion time is small
its accuracy is high
its output is in BCD
it does not require a comparator

⇒ In following figure find V_GG by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
0.67 V
6.7 V
7 V
0.3 V

⇒ For the infix expression (A/B) * (C * F + (A - D) * E) the corresponding Post fix notation is
A / D * CF AD - F * +
AB / CF * AD - E * + *
AB / C * FAD - E * + *
None of the above

⇒ The programming language in which Excel records the macro code is
basic
visual basic
video basic
basic 2

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ Eddy current loss is
proportional to frequency
independent of frequency
proportional to (frequency)²
proportional to (frequency)³

⇒ In given figure the switch was closed for a long time before opening at t = 0. The voltage V_x at t = 0^{+25 V
50 V
-50 V
0 V}

⇒ Electric dipole moment is expressed in debye unit.
TRUE
FALSE

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only

⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A

⇒ For class B operation the theoretical maximum efficiency is
1
0.785
0.5
0.275

⇒ The effective value of the waveform in the given figur
5
2.5
2.5
5.0

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ An ac network has two sources of the same frequency. The currents in one branch when the sources act independently are 10 ∠30° A and 10 ∠60° A. When both sources act, the current in the branch should be
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ In a CE amplifier the ac emitter resistance
is zero
is high
is very high
may have any value

⇒ Which element exhibits the property of inertia?
Resistance
Capacitance
Inductance
Both resistance and inductance

⇒ The transition of electron from energy level W₁ to W₂ is associated with emission or absorption of electro magnetic radiation of frequency f such that
hf = |W₁ - W₂|
|W₁ - W₂|f = h
hf = 0.5|W₁ - W₂|
(hf)² = |W₁ - W₂|

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ In DTL the junction transistor serves as
inverter
buffer amplifier
both (a) and (b)
none of the above

⇒ If the thermal resistance of a transistor is lower it means
higher junction temperature
lower junction temperature
higher or lower junction temperature depending on circuit conditions
higher or lower junction temperature depending on transistor

⇒ A single phase series converter is used for
high voltage output
high current output
high voltage and high current output
improving the circuit efficiency

⇒ Hall effect can be used to find the type of semiconductor.
TRUE
FALSE

⇒

Assertion (A): In an automobile the amount of fuel admitted to the engine is adjusted as per the difference between desired and actual speed.

Reason (R): The control signal is the amount of fuel to be admitted to the engine.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ Whenever a JFET operates above pinch-off voltage
depletion regions become smaller
drain current increase steeply
drain current starts decreasing
drain current remains nearly constant

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases