Question is ⇒ Tropospheric scatter is used with frequencies in the range of, Options are ⇒ (A) VLF, (B) HF, (C) UHF, (D) VHF, (E) , Leave your comments or Download question paper.

Question is ⇒ Tropospheric scatter is used with frequencies in the range of, Options are ⇒ (A) VLF, (B) HF, (C) UHF, (D) VHF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Tropospheric scatter is used with frequencies in the range of
A.	VLF [Wrong Answer]
B.	HF [Correct Answer]
C.	UHF [Wrong Answer]
D.	VHF [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ For addition and subtraction operations, phasors
must be represented in polar form
must be represented in rectangular form
may be represented in any form
none of the above

⇒ A plane EM wave is travelling in an unbound loss less dielectric having μ_y = 1 and ε_y = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity v_p (assuming velocity of light as 3 x 10⁸ m/sec) is
1.5 x 10⁸ m/sec
3 x 10⁸ m/sec
2.5 x 10⁸ m/sec
0.5 x 10⁸ m/sec

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
becomes zero
abruptly decrease
abruptly increases
remains constant

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.
TRUE
FALSE

⇒ A 10 bit ADC with a full scale output voltage of 10.24 V is to be designed to have ± LSB/2 accuracy. If ADC is calibrated at 25°C, the maximum net temperature coefficient of ADC should not exceed
± 200 μV/°C
± 400 μV/°C
± 600 μV/°C
± 800 μV/°C

⇒ A single phase semiconverter is supplying RLE load and has a freewheeling diode across the load. The firing angle is a. The freewheeling diode conducts for
a° in each half cycle
(p - a)° in each cycle
a° in one full cycle
(p + a)° in each half cycle

⇒ The saving of power in DSB-SC modulated at 80% is
NIL
0.8
0.7576
0.5

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)

⇒ A balanced modulator circuit uses
two identical diodes with same V-I characteristics
two triodes with different V-I characteristics
two diodes with different V-I characteristics
a diode and a triode

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ The voltage of the source in circuit shown __________ if i(t) = - 20e^{-2t46.6 e^-2t
47 e^-2t
50 e^-2t
0}

⇒ A relaxation oscillator uses
tunnel diode
UJT
both tunnel diode and UJT
PIN diode

⇒ An electrostatic voltmeter is suitable for
low voltage at high frequency
high voltage
low voltage at low frequency
all ac and dc voltages

⇒ A transmitter power of 10 W is increased by 30 dB. The effective radiated power is
100 W
1000 W
10000 W
100000 W

⇒ Consider the following statements about hybrid ring

Ports 1 and 2 are decoupled.
Port 3 and 4 are coupled.
A signal entering either port 1 or 2 splits equally between ports 3 and 4.
A signal entering either port 3 or 4 splits equally between ports 1 and 2.

Which of the above are correct?
1, 2, 3 and 4
1, 3 and 4
1 and 2
2, 3 and 4

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A network has 10 nodes and 17 branches. The number of different node pair are
7
9
10
45

⇒ The logic function implemented by the following circuit at the terminal OU
P NOR Q
P NAND Q
P OR Q
P AND Q

⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes

⇒ Which device has one input and many outputs?
Multiplexer
Demultiplexer
Counter
Flip flop

⇒ In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be
A
B
C
AB

⇒ V-I relationship of a network N is given by, V = 8 -
0, 2
0, 4
2, 4
None of these