Question is ⇒ Transport lag usually exists in, Options are ⇒ (A) thermal systems, (B) hydraulic systems and thermal systems, (C) pneumatic systems, (D) thermal, hydraulic and pneumatic systems, (E) , Leave your comments or Download question paper.

Question is ⇒ Transport lag usually exists in, Options are ⇒ (A) thermal systems, (B) hydraulic systems and thermal systems, (C) pneumatic systems, (D) thermal, hydraulic and pneumatic systems, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Transport lag usually exists in
A.	thermal systems [Wrong Answer]
B.	hydraulic systems and thermal systems [Wrong Answer]
C.	pneumatic systems [Wrong Answer]
D.	thermal, hydraulic and pneumatic systems [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following pairs are correctly matched?

Brune's realisation : realisation with ideal transformer.
Cauer realisation : ladder realisation.
Bott Duffin realisation : with non ideal transformer.

Select the answer using the following codes:
1, 2 and 3
2 and 3
1 and 3
1 and 2

⇒ A planar array radar uses a high gain planar array antenna.
TRUE
FALSE

⇒ FIR digital filter having __________ stability than FIR filter.
good stability
poor stability
stability not guarnteed
poor stability

⇒ A MASER is a
low noise device
high noise device
medium noise device
may be either high or medium noise device

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ If antenna diameter is increased four times, the maximum range is increased by a factor of
2
2
4
0.2

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ For a two- port reciprocal network, the output open circuit voltage divided by the input current is equal to
B
Z₁₂
1/y₁₂
h₁₂

⇒ The expression Y (A, B, C) = ∑m (1, 3, 5, 6) is to realized using a multiplexer. Then
use 8 : 1 multiplexer and ground input lines 1, 3, 5, 6
use 8 : 1 multiplexer and ground input lines 0, 2, 4, 7
use 8 : 1 multiplexer and ground input lines 0, 1, 2, 3
use 8 : 1 multiplexer and ground input lines 4, 5, 6, 7

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ In the analysis of common emitter amplifier we may neglect
h_re
h_oe
h_fe
h_ie

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300 K will be (in m²/s)
0.4
0.16
0.04
0.01

⇒ It is best to use for coupling a coaxial line to a parallel wire transmission line.
directional Coupler
balun
slotted line
tee

⇒ For a transfer function H(s) = P(s)/Q(s), where P(s) and Q(s) are polynomials in s
the degrees of P(s) is always greater than degree of Q(s)
the degree of P(s) and Q(s) are equal
the degree of P(s) is independent of degree of Q(s)
the maximum difference in degrees of P(s) and Q(s) is 1

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ + M
L₁ + L₂ + 2M
L₁ + L₂ + M

⇒ Which of the following sampling frequencies is considered adequate in voice telephony?
4 kHz
8 kHz
16 kHz
32 kHz

⇒ In using KCL it is necessary that current leaving a node is written as negative.
TRUE
FALSE

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒ An ac bridge uses galvanometer as detector.
TRUE
FALSE

⇒ Which one is a causal system?
y(n) = 3x[n] - 2x[n - 1]
y(n) = 3x[n] + 2x[n + 1]
y(n) = 3x[n + 1] + 2x[n - 1]
y(n) = 3x[n + 1] 2x[n - 1] + x[n]

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ Which one of following is correct for broadside array?
Direction of radiation is perpendicular to axis
Also perpendicular to the plane
Current is fed of equal amplitude equal phase
All

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be
1.116
1.386
2.116
2.386

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ The current gain of a transistor is the ratio of
emitter current to base current
emitter current to collector current
collector current to base current
collector current to emitter current