Question is ⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because, Options are ⇒ (A) d.c. resistance is low, (B) collector voltage is stepped up, (C) flux linkages are incomplete, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because, Options are ⇒ (A) d.c. resistance is low, (B) collector voltage is stepped up, (C) flux linkages are incomplete, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Transformer coupling in transistor amplifier circuits provides high efficiency, because
A.	d.c. resistance is low [Correct Answer]
B.	collector voltage is stepped up [Wrong Answer]
C.	flux linkages are incomplete [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A heavily doped semiconductor exhibits a __________ such a device is called sensistors.
negative temperature coefficient of resistance
positive temperature coefficient of resistance till a particular value of temperature and then it shown negative temperature coefficient of resistance
positive temperature coefficient of resistance
none of the above

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.
more than 100
100
less than 100
50

⇒ Which of the following terms are equivalent?

A ⊕ B ⊕ C
A ⊕ B ⊙ C
A ⊙ B ⊕ C
A ⊙ B ⊙ C

1 and 4; 2 and 3
1 and 3
2 and 3
1, 2 and 4

⇒ In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in
positive clipping of collector current
negative clipping of collector current
both positive and negative clipping of collector current
either positive or negative clipping of collector current

⇒ The minimum value of h_fe of a transistor used in RC phase shift oscillator is
54.4
45.4
44.5
29

⇒ For a quadratic factor in denominator of transfer function the phase angle at corner frequency (in Bode phase angle plot)
is -90°
is +90°
depends on the damping factor
none of the above

⇒ The equivalent form of the logical expression ABC + A BC + ABC + ABC + AB C is
C + (A ⊕ B)
(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)

⇒ The correct hierarchy of operations for the operators & &, = = , = , * is
& & , = = , = , *
* , = = , & & , =
* , & & , = = , =
= , & & , = = , *

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ T- FF used as a
transfer Data switch
toggle switch
time delay switch
none

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ Which of the following noise does not occur in transistors?
Partition noise
Shot noise
Flicker noise
Resistance noise

⇒ Ohmic range of metal film resistors is
1 to 100 ohms
10 to 1 K ohms
100 to 1 M ohms
100 to 100 M ohms

⇒ The open loop gain of an actual op-amp is about 100.
TRUE
FALSE

⇒ Which of the following is most likely to be found in an SSB transmitter?
Class A, RF output amplifier
Class B, RF amplifier
Tuned modulator
Class C, audio amplifier

⇒ Generally a VCR has
four stationary video heads
two stationary video heads
four rotating video heads
two rotating video heads

⇒ A full wave rectifier using centre tapped transformer and a bridge rectifier use similar diodes and have equal no load output voltage. Under equal load conditions
Output voltage of bridge rectifier
Output voltage of bridge rectifier will be more than that of other
Output voltage of both will be exactly equal
Output voltage of any one may be more than that of other

⇒ δ(t) is a
energy signal
power signal
neither energy nor power
none

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ A (75 - J50) ohm load is connected to a coaxial of Z₀ = 75 ohm at 10 GHz. The best method of matching is to connect
an inductance at load
a short circuited stub at load
a short circuited stub at specific distance from load
a capacitance at specific distance from load

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ In the given fi
42737
42739
2
1

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ For a nonlinear resistance
v-i plot is not a straight line
resistance increases as current increases
resistance decreases as current increases
current decreases as voltage increases