Question is ⇒ To turn off an SCR, it is necessary to reduce its current to less than :, Options are ⇒ (A) trigger current, (B) holding current, (C) breakover current, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ To turn off an SCR, it is necessary to reduce its current to less than :, Options are ⇒ (A) trigger current, (B) holding current, (C) breakover current, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To turn off an SCR, it is necessary to reduce its current to less than :
A.	trigger current [Wrong Answer]
B.	holding current [Correct Answer]
C.	breakover current [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒ Brownian motion is
random emission of electrons in vacuum tubes
thermal motion of electrons in a resistance
random diffusion of holes and electrons in semi- conductors
both (b) and (c)

⇒ A 4 input AND gate is equivalent to
4 switches in parallel
2 switches in series and 2 in parallel
three switches in parallel and one in series
4 switches in series

⇒ A 10 MHz square wave clocks 5 bit ripple counter. The frequency of the 3rd FF output is
2 MHz
1.25 MHz
50 MHz
615 kHz

⇒ Consider the following features of 'structures' in C?

The values of a structure variable can be assigned to another structure variable of the same type using the assignment operator.
One structure can be nested within another structure.
A variable structure can also be passed to a function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The equivalent resistance between terminals x and y figur
150 Ω
45 Ω
55 Ω
35 Ω

⇒ The logic circuit of the given figure realizes the func
(A + B + C)(D)(E)
(A + B + C) (D)(E)
(A + B = C) (D)(E)
(A + B + C)(D)(E)

⇒ The conductivity of an intrinsic semiconductor is (symbols have the usual meanings).
generally less than that a doped semiconductor
σ_i = en_i (μ_n - μ_p)
σ_i = en_i (μ_n + μ_p)
σ_i = n_i (μ_n - μ_p)

⇒ A scheme shown below is to generate a wide band FM modulate sign
88 MHz, 112 MHz
96 MHz, 104 MHz
92 MHz, 108 MHz
90 MHz, 110 MHz

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
will increase
will decrease
will remain constant
will reduce to negligible value

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ McMurray Bedford full bridge inverter uses
natural commutation
auxiliary commutation
complementary commutation
any of the above

⇒ In AM receiver the oscillator frequency is
always equal to signal frequency
always equal to 455 kHz
always higher than signal frequency
always lower than signal frequency

⇒ The stationary process has
all the statistical Properties dependent on time.
all the statistical Properties independent of time.
aime average is equal to ensemble average.
zero variance.

⇒ Consider a silicon p-n junction at room temperature having the following paramet
is 0.70V
is 0.76V
is 0.82V
cannot be estimated from the data given

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ The frequency at which magnitude of closed loop frequency response is 3 dB below its zero frequency value is called critical frequency.
TRUE
FALSE

⇒ E_g is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?
Strong dielectric
Regular
Rough
High loss

⇒ The value of VSWR is taken as ∞ when the line is
short-circuited
open-circuited
terminated with full load
terminated with load equal to the characteristic impedance of the load

⇒ Consider the following statements about conditions that make a metal semiconductor contact rectifying

N type semiconductor with work function φ_s more than work function φ_M of metal
N type semiconductor with work function φ_s less than work function φ_M of metal
P type semiconductor with work function φ_s more than work function φ_M of metal
P type semiconductor with work function φ_s less than work function φ_M of metal.

Of these statements
1 and 3 are correct
2 and 3 are correct
1 and 4 are correct
2 and 4 are correct

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ Two coil have their axis perpendicular to each other. The coefficient of coupling k is
1
0.5
more than 0 but less than 1
0

⇒ A land line telemetry system is suitable for distance upto
about 1 km only
about 10 km only
about 100 km only
any of the above

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ A two stage amplifier has an upper cutoff frequency of 2 MHz and a lower cutoff frequency of 2 MHz and a lower cut off frequency of 30 Hz. If both stages are similar, their individual upper and lower cut off frequencies respectively are
4 MHz and 60 MHz
3 MHz and 20 Hz
3 MHz and 60 Hz
4 MHz and 20 Hz