Question is ⇒ To measure moisture in wood, the most suitable method is, Options are ⇒ (A) electric conduction, (B) electrical-capacitive, (C) absorption of radiation, (D) equilibrium-moisture Vs humidity, (E) , Leave your comments or Download question paper.

Question is ⇒ To measure moisture in wood, the most suitable method is, Options are ⇒ (A) electric conduction, (B) electrical-capacitive, (C) absorption of radiation, (D) equilibrium-moisture Vs humidity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To measure moisture in wood, the most suitable method is
A.	electric conduction [Correct Answer]
B.	electrical-capacitive [Wrong Answer]
C.	absorption of radiation [Wrong Answer]
D.	equilibrium-moisture Vs humidity [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ By the use of which of the following the PPM can be converted to PWM?
A stable multivibrator
Integrator
Monostable multivibrator
Bistable Multivibrator

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ A telephone user while talking to a person via a satellite has to wait for reply for about __________ millisecond.
100
270
470
540

⇒ For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is
output voltage
input voltage
voltage drop across thyristor
none of the above

⇒ In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be
A
B
C
AB

⇒ The properties of FETs closely resemble those of a
thermionic valve
P-N-P transistor
N-P-N transistor
UJT

⇒ Wagner earthing device eliminates
all stray capacitance in the circuit
stray capacitances between components
stray capacitance between detector terminal and ground
mutual coupling between components

⇒ The polar plot of a transfer function passes through (-1, 0) point. The gain margin is
zero
- 1 dB
1 dB
infinity

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ n-type semiconductors
are negatively charged
are produced when indium is added as impurity to germanium
are produced when phosphorus is added as impurity to silicon
none of the above

⇒ Consider the following statements regarding negative feedback

It increases system gain
It improves sensitivity
It improves system stability

Which of these are not correct?
all
1, 2
1, 3
1 only

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ In a bipolar transistor, emitter efficiency is about
0.99
0.9
0.8
0.7

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ The radix of a hexadecimal system is
2
3
8
16

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is
20 dB more
20 dB less
700 dB more
100 dB less

⇒ Which of the following is the digital system?
PWM
PAM
PPM
PCM

⇒ A capacitor can be represented by a capacitance and resistance in parallel. For a good capacitor, this parallel resistance should be
negligible
low
high
very high

⇒ The gate-source voltage that reduces the drain current to approximately zero is called
gate-source on voltage
gate-source voltage
pinch-off voltage
gate-source cut-off voltage

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode

⇒ The resistance of series field winding is a low resistance.
TRUE
FALSE

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect

⇒ The method of triggering SCS is
application of positive pulse at cathode gate or negative pulse at anode gate
application of pulse at anode gate
application of pulse at cathode gate
application of low voltage at anode

⇒ The slope of log-magnitude asymptote changes by - 40 dB/ decade at a frequency ω₁. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
a pole or zero at origin is present

⇒ In a circular waveguide the dominant mode is
TE₀₁
TE₁₁
TE₂₀
TE₂₁