Question is ⇒ To measure a resistance by a dc potentiometer, Options are ⇒ (A) it is necessary to standardise the potentiometer, (B) it is not necessary to standardise the potentiometer, (C) it is necessary to use a volt ratio box, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ To measure a resistance by a dc potentiometer, Options are ⇒ (A) it is necessary to standardise the potentiometer, (B) it is not necessary to standardise the potentiometer, (C) it is necessary to use a volt ratio box, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To measure a resistance by a dc potentiometer
A.	it is necessary to standardise the potentiometer [Wrong Answer]
B.	it is not necessary to standardise the potentiometer [Correct Answer]
C.	it is necessary to use a volt ratio box [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒ A CW transmitter radiates
modulated RF carrier
unmodulated RF carrier
both (a) and (b)
none of the above

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ Pick the odd-one out
Hartley Oscillator
Colpitt oscillator
Clapp oscillator
Weinbridge oscillator

⇒ The effect of adding poles and zeros can be determined quickly by
Nichols chart
Nyquist plot
Bode plot
Root locus

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ Which of the following identifiers is valid in Pascal?
THETA
NUM
1 ST
$ BETA

⇒ Choose the correct option, if b (branch), n (nodes), l (links)
b = n + l - 1
no. of twig = n - 1
b = n - l + 1
b, a

⇒ If KMT = 100, LITRES = 5.0, PCOST = 28.0 and OPCOST = 70.0 what will be the result of the following FORTRAN 77 program? 2
2.1
21
21

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B

⇒ For a NPN bipolar transistor, what is the main stream of current in the base region?
Drift of holes
Diffusion of holes
Drift of electrons
Diffusion of electrons

⇒ The source of which of the following noise is different from that of the remaining?
Solar noise
Cosmic noise
Galactic noise
Atmospheric noise

⇒ A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled, then the voltage across each resistor is
half
doubled
increase by 4 times
no change

⇒ In the op-amp circuit of figure, V_{010 V
-10 V
5 V
-5 V}

⇒ Bus bars are always meant for very heavy currents.
TRUE
FALSE

⇒ An LED is
an ohmic device
a display device
a voltage regulated device
all of the above

⇒ In active filters inductances are divided because they
are always associated with same resistance
are bulky and unsuitable for miniaturization
are non linear
saturate quickly

⇒ Consider the following statements about radar Beacon

It is also called transponder.
It includes pulse transmitter, receiver and antenna.
It replies with full power even when the signal receives is weak.

Which of the above statements are correct?
All
1 and 2 only
2 and 3 only
2 only

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ Photo electric emission can occur only if
wave length of incident radiation is equal to threshold value
wave length of incident radiation is less than threshold value
frequency of incident radiation is less than threshold frequency
none of the above

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ An integrating amplifier has resistance in feedback path.
TRUE
FALSE

⇒ Microprocessor 8088 has
16 bit registers and 16 bit data bus
8 bit registers and 8 bit data bus
8 bit registers and 16 bit data bus
16 bit registers and 8 bit data bus

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ Which of the following radio waves are not reflected by ionosphere?
Waves above 1 kHz
Waves above 1 MHz
Waves above 10 MHz
Waves above 30 MHz

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ All of the following elements have three valence electrons EXCEPT
boron
indium
gallium
arsenic

⇒

Assertion (A): Capacitance effect can be used to measure thickness of sheets, displacement and pressure.

Reason (R): Capacitance between two plates depends on the area of plates, distance between plates and permittivity of medium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are
100 Hz and 50 Hz
50 Hz and 100 Hz
100 Hz each
50 Hz each