Question is ⇒ To find the current in a 20 Ω resistance connected in a circuit, Norton's theorem is used. I<sub>N</sub> = 7.5 A. The current though 20 Ω resistance., Options are ⇒ (A) is 7.5 A, (B) is less than 7.5 A, (C) may be 7.5 A or less, (D) may be 7.5 A or more or less, (E) , Leave your comments or Download question paper.

Question is ⇒ To find the current in a 20 Ω resistance connected in a circuit, Norton's theorem is used. I<sub>N</sub> = 7.5 A. The current though 20 Ω resistance., Options are ⇒ (A) is 7.5 A, (B) is less than 7.5 A, (C) may be 7.5 A or less, (D) may be 7.5 A or more or less, (E) , Leave your comments or Download question paper. N = 7.5 A. The current though 20 Ω resistance., Options are ⇒ (A) is 7.5 A, (B) is less than 7.5 A, (C) may be 7.5 A or less, (D) may be 7.5 A or more or less, (E) , Leave your comments or Download question paper. '/> N = 7.5 A. The current though 20 Ω resistance., Options are ⇒ (A) is 7.5 A, (B) is less than 7.5 A, (C) may be 7.5 A or less, (D) may be 7.5 A or more or less, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	To find the current in a 20 Ω resistance connected in a circuit, Norton's theorem is used. I_N = 7.5 A. The current though 20 Ω resistance.
A.	is 7.5 A [Wrong Answer]
B.	is less than 7.5 A [Correct Answer]
C.	may be 7.5 A or less [Wrong Answer]
D.	may be 7.5 A or more or less [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ IC 74181 has two select lines.
TRUE
FALSE

⇒ Inverter 74 LS04 has following specifications I_0H max = - 0.4 mA, I_{0L max} = 8 mA, I_{IH max} = 20 μA, I_{IL max} = 0.
10
20
60
100

⇒ Which of the following is open loop system?
Wind screen wiper
Aqualing
Respiratory system of animal
System for controlling antirocket missiles

⇒ A duplexer is a device used to
feed more than one receiver from a single antenna
connect two transmitters to the same antenna
connect a receiver and a transmitter to the same antenna
none of these

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ The condition AD - BC = 1 for two port network implies that the network is a
reciprocal
lumped element network
lossless network
unilateral element network

⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper

⇒ Klystron amplifier is not used to amplifier very weak microwave signals due to
low gain for weak signals
low noise for weak signals
high noise
both (a) and (b)

⇒ Which device can detect the presence of both forward and backward waves in a waveguide?
Filter
Detector
Directional coupler
Magic T

⇒ For very low frequencies, v₀/v_i in the given figure eq
1
0
∞
0.5

⇒ A parallel connection of circuit is at below resonance circuit behave as
RC circuit
RL
RLC
resistive only

⇒ Which of the following statements is not correct for thermistors?
They have negative temperature coefficient of resistance
The sensing element is made of sintered ceramics, which are oxides of metals in the form of beads
The variation of resistance with temperature is linear
The resistance value at ambient temperature may range from 100 Ω to 100 kΩ

⇒ n channel FETs are better as compared to p-channel FET because
they are more efficient
they have high switching time
they have higher input impedance
mobility of electrons is more than that of holes

⇒ In case of probability of the message is 1 to 16 then the information will be
16 bits
8 bits
4 bits
2 bits

⇒ In the transformer shown in figure, the inductance measured across terminal 1 and 2 was 4 H with terminals 3 and 4 open. It was 3H when terminals 3 and 4 are short circuited. The coefficient of couplin
1
0.707
0.5
indeterminate due to insufficient data

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ The pointer of an indicating instrument should be
very light
very heavy
neither heavy nor light
heavy

⇒ In terrestrial microwave links, the number of 'fades' per unit increases as
both the transmission and the distance between the antennas are increased
the transmission frequency is increased but the distance between the antennas is decreased
the transmission frequency is decreased but the distance between the antennas is increased
both the transmission frequency and distance between the antennas are decreased

⇒ Which of the following devices is used in the microprocessors?
JFET
BJT
MOSFET
CMOS

⇒

Assertion (A): In AM, use of SSB reduces the power and bandwidth requirement

Reason (R): A balanced modulator produces AM with carrier suppressed

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?
Voltmeter having a resistance of 5 kΩ
Voltmeter having a sensitivity of 1 kW/V
Voltmeter having sensitivity of 10 kW/V
None of the above

⇒ Which is correct for a transfer function?
The poles and zero must be complex
If the poles and zeros are complex or imaginary, they must be conjugate
If the poles and zeros are complex they must be simple
If a zero is imaginary, it must be simple

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ The phase of colour subcarrier burst in PAL is along the axis at
+180°
-180°
±180°
±45°

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is
r = 0.5, S is required
r = 1.0, S is required
r = 0.5, S is not required
r = 1.0, S is not required

⇒ Which of the following is incorrect?
(8)₁₆ = (8)₈
(5)₁₆ = (5)₈
(8)₂ = (2)₁₀
(2)₁₆ = (2)₁₀

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say