Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
To ensure that only dominant TE_{10} mode propagates in a rectangular waveguide, the operating frequency | |
A. | must be more than cutoff frequency of TE_{10} mode [Wrong Answer] |
B. | must be less than cutoff frequency of TE_{20} mode [Wrong Answer] |
C. | must be more than cutoff frequency of TE_{10} mode and less than cutoff frequency of TE_{20} mode [Correct Answer] |
D. | must be less than cutoff frequency of TE_{10} mode [Wrong Answer] |
View Answer
Explanation:-
Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ In following figure find V_{GG} by assuming gate current is negligible for the p-channel JFET. (if I_{DQ} = - 6 mA, R_{S} = 0, V_{DD} = -18 V, R_{D} = 2 kΩ, I_{DSS} = - 10 mA, I_{PO} = - 3 V)
0.67 V
6.7 V
7 V
0.3 V
⇒ Calculate the stability factor and change in I_{c} from 25°C to 100°C for, β = 50, R_{B}/R_{E} = 250, ΔI_{CO} = 19.9 nA for emitter bias configuration
42.553, 0.85 μF
40.91, 0.58 μF
38.53, 0.85 μF
41.10, 0.39 μF
⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A
⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above
⇒ The MOSFET is almost ideal as a switching device because
it has linear characteristics
it works progressively
it consumes low power
it has longer life
⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25
⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz
⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna
⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement
⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W
⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D
⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative
⇒ The series 54 H/74 H denotes
Standard TTL
High speed TTL
Low Power TTL
High Power TTL
⇒ Generally, the gain of a transistor amplifier falls at high frequency due to the
internal capacitance of the device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P
⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2
⇒ At high frequencies the output circuit of transistor amplifier reduces to
a lead network
a lag network
either (a) or (b)
neither (a) nor (b)
⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0^{+} the current supplied by batter
0
0.208333333333333
less than 5A
infinity
⇒ The statement that the line integral of magnetic field about any closed path is exactly equal to the direct current enclosed by that path, is known as
Ampere's circuital law
Coulomb's law
Electrostatic's theory
None of the above
⇒ The first and the last critical frequency of an RC driving point impedance function must respectively by
a zero and a pole
a zero and a zero
a pole and a pole
a pole and a zero
⇒ A signal m(t) amplitude modulates a carrier A_{c} cos ω_{c}t. The final signal will be
[A_{c} m(t)] cos ω_{c}t]
A_{c} . [1 + m(t)] cos ω_{c}t
A_{c} + [m(t)] cos ω_{c}t
A_{c} cos ω_{c}t + m(t)
⇒ If operator 'a' = 1 ∠120° then (1 + a) =
-a
-a^{2}
a
-1
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct
⇒ In amplifiers, the parasitic oscillation result due to
transistor inter junction capacitance
push pull operator
negative feedback
poor inter-stage coupling
⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased
⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple
⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8
⇒
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above
⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C
⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above
⇒ In following figure find V_{GG} by assuming gate current is negligible for the p-channel JFET. (if I_{DQ} = - 6 mA, R_{S} = 0, V_{DD} = -18 V, R_{D} = 2 kΩ, I_{DSS} = - 10 mA, I_{PO} = - 3 V)
0.67 V
6.7 V
7 V
0.3 V
⇒ Calculate the stability factor and change in I_{c} from 25°C to 100°C for, β = 50, R_{B}/R_{E} = 250, ΔI_{CO} = 19.9 nA for emitter bias configuration
42.553, 0.85 μF
40.91, 0.58 μF
38.53, 0.85 μF
41.10, 0.39 μF
⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A
⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above
⇒ The MOSFET is almost ideal as a switching device because
it has linear characteristics
it works progressively
it consumes low power
it has longer life
⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25
⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz
⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna
⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement
⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W
⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D
⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative
⇒ The series 54 H/74 H denotes
Standard TTL
High speed TTL
Low Power TTL
High Power TTL
⇒ Generally, the gain of a transistor amplifier falls at high frequency due to the
internal capacitance of the device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P
⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2
⇒ At high frequencies the output circuit of transistor amplifier reduces to
a lead network
a lag network
either (a) or (b)
neither (a) nor (b)
⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0^{+} the current supplied by batter
0
0.208333333333333
less than 5A
infinity
⇒ The statement that the line integral of magnetic field about any closed path is exactly equal to the direct current enclosed by that path, is known as
Ampere's circuital law
Coulomb's law
Electrostatic's theory
None of the above
⇒ The first and the last critical frequency of an RC driving point impedance function must respectively by
a zero and a pole
a zero and a zero
a pole and a pole
a pole and a zero
⇒ A signal m(t) amplitude modulates a carrier A_{c} cos ω_{c}t. The final signal will be
[A_{c} m(t)] cos ω_{c}t]
A_{c} . [1 + m(t)] cos ω_{c}t
A_{c} + [m(t)] cos ω_{c}t
A_{c} cos ω_{c}t + m(t)
⇒ If operator 'a' = 1 ∠120° then (1 + a) =
-a
-a^{2}
a
-1
⇒
Assertion (A): In microprocessor 8085 instruction LXIB, 90 FF H means register B and C are loaded with upper and lower bytes to get B = 90 H and C = FFH.
Reason (R): In 8085 the stack pointer indicates which memory location is to accessed.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct
⇒ In amplifiers, the parasitic oscillation result due to
transistor inter junction capacitance
push pull operator
negative feedback
poor inter-stage coupling
⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased
⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple
⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8
⇒
Assertion (A): In class A amplifier the distortion is minimum
Reason (R): In class A amplifier collector current exists for 360° of input cycle
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above
⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C
⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above