Question is ⇒ To convert JK flip flop to D flip flop, Options are ⇒ (A) connect D to both J and K, (B) connect D to J directly and D to K through inverter, (C) connect D to K directly and D to J through inverter, (D) connect D to K and leave J open, (E) , Leave your comments or Download question paper.

Question is ⇒ To convert JK flip flop to D flip flop, Options are ⇒ (A) connect D to both J and K, (B) connect D to J directly and D to K through inverter, (C) connect D to K directly and D to J through inverter, (D) connect D to K and leave J open, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	To convert JK flip flop to D flip flop
A.	connect D to both J and K [Wrong Answer]
B.	connect D to J directly and D to K through inverter [Correct Answer]
C.	connect D to K directly and D to J through inverter [Wrong Answer]
D.	connect D to K and leave J open [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒ The percentage limiting error in an instrument reading 8.3 V and having guaranteed accuracy of 1% of the full scale reading and range of 0-150 V is
0.0181
0.00181
0.181
0.000018

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ A loop antenna is a commonly used for
radar
direction finding
satellite communication
all of the above

⇒ For a reflection co-efficient of 0.5, the value of SWR is
-1
1
2
3

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒

Match the following:

	List I (Command in WORD)		List II (Meaning)
A.	END	1.	The bar displays the current position of cursor
B.	HOME	2.	Moves cursor to the beginning of current line
C.	Status	3.	Moves cursor to end of document

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-3, C-1
A-3, B-2, C-1

⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub
is more difficult to fabricate and construct
is made of transmission line of different Z₀
is liable to radiate
is incapable of giving full range of reactance

⇒ A cascade amplifier will have higher cut off frequency
equal to that of single stage amplifier
less than that of single stage amplifier
more than that of single stage amplifier
none of these

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ As per Matthiessen's rule, the total resistivity r of a conductor can be written as r = r_i + aT, where r_i and a are constants and T is absolute temperature. At very low temperatures
aT = 0
aT > r_i
aT ∼ r_i
aT < r_i

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ In figure, transistor β_dc = 100 and LED voltage when it is conducting is 2 V. Then the base current which saturates the transisto
18 mA
1.8 mA
0.18 mA
0.018 mA

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of
6
1
8
9

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ When two conductors carry currents in the same direction the force is repulsive.
TRUE
FALSE

⇒ In satellite communication, highly directional antennas are used to
direct the spot beam to a particular region of space on Earth
strengthen the beam to overcome the cosmic noise
make corrections in change of polarisation of the beam
select a particular channel in transmission and reception

⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
low leading
low lagging
high leading
very low lagging

⇒ In figure it is desired that output wave is symmetrical.
both diodes should be similar and |V₁| = |V₂|
both diodes should be similar
|V₁| = |V₂|
either (a) or (b)

⇒ The rate of change of excess carrier density is proportional to carrier density.
TRUE
FALSE

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ Medium scale integration refers to ICs with
more than 12 but less than 30 gates on the same chip
more than 50 gates on the same chip
more than 20 but less than 100 gates on the same chip
more than 12 but less than 100 gates on the same chip

⇒ The dual of quantity charge is
current
Voltage
flux
dΦ/dt