Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | To bypass a 100 ohm emitter resistor at |

A. | 10 μF [Wrong Answer] |

B. | 100 μF [Wrong Answer] |

C. | 1000 μF [Correct Answer] |

D. | 1 μF [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Degaussing in a picture tube means

Adding magnetism in mask and mounting frame

Removing residual magnetism in mask, shield etc...

Increasing resistance of coils to decrease time constant

Decreasing resistance of coils to increase time constant.

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to

reduce the required bandwidth

improve resolution

reduce peak power requirement

make interlacing easier

⇒ In Bode plots, frequency is plotted on log scale.

TRUE

FALSE

⇒ RECTIFIER : OSCILLATOR ::

Capacitance : Inductance

Series resonance : Parallel resonance

DC : AC

Regulation : Efficiency

⇒ A certain transistor has a

_{dc}of 0.98 and a collectors leakage current of 5 μA. If I

_{E}= 1 mA, the base current will be

35 μA

25 μA

15 μA

5 μA

⇒ Hari (H), Gita (G), Irfan (I) and Saira (S) are sibiligs (i.e. brothers and sisters). All were born on 1st January. The age difference between any two successive siblings (that is born one after another) is less than 3 years. Given the following fa

HSIG

SGHI

IGSH

IHSG

⇒ A function

*f*(

*t*) =

*k*is

stable

marginal stable

unstable

none

⇒ Find the value of

*i*if each resistance is of 3 Ω and each battery is of

_{x}1.1428 V

1.432 A

0.2892 A

O A

⇒ A network N is dual of network N if

both of them have same mesh equation

both of them have same node equation

mesh equation of one are the node equations of the other

KCL and KVL equations are the same

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be

196 W

73 W

36.5 W

18.25 W

⇒

Match the following:

List I (Functional headings of instruction set of 8085) | List II (Functions performed) | ||
---|---|---|---|

A. | Branch group | 1. | Compares, rotates etc. |

B. | Logic group | 2. | Moves, loads, stores etc. |

C. | Data transfer group | 3. | Initiates conditional or unconditional jumps, calls etc. |

A-1, B-2, C-3

A-2, B-3, C-1

A-3, B-1, C-2

A-1, B-3, C-2

⇒ If the switch is thrown to the START position, Q and Y will be equal to

Q = 0, Y = 0

Q= 1, Y= 1

Q = 1, Y = CLK

Q = 0, Y = CLK

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will

increased by 6 dB

increased by 12 dB

decreased by 6 dB

decreased by 12 dB

⇒ Consider the following as regards cumulative disribution function F(

*x*)

- 0 ≤ F(
*x*) ≤ 1 - F(- ∞) = 0
- F(∞) = 1
- F(
*x*_{1}) ≤ F(*x*_{2}) If*x*_{1}<*x*_{2}

1 and 2 only

1, 2 and 3 only

1, 2, 3 and 4

2 and 4

⇒ The kinetic energy of photoelectrons emitted by a photo sensitive surface depends on

intensity of the incident radiation

wavelength of the incident radiation

surface conditions of the surface

angle of incidence of radiation

⇒ Power is drawn from a source at power factor 0.7. P

_{av}= 300 watt. The reactive power is

0

105

100 VA

107 VA

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if

*z*

_{0}= 500 ohms, the admittance

*y*seen at the function of the stub and the transmission line

(0.01 -

*j*0.02) mho

(0.02 -

*j*0.01) mho

(0.04 -

*j*0.02) mho

(0.02 +

*j*0) mho

⇒ In the circuit of figure, the switch is closed at

*t*= 0 with

*i*

_{L}(0) = 0 and V

_{C}(0) = 0. In the steady state n

_{c}equ

100

*v*

0

*v*

∞

- 100

*v*

⇒ The mobility of e

^{-}for Ge and Si respectively is

1.66, 2.5

2.5, 1.66

2.7, 2.33

2.33, 2.7

⇒ In Bode diagram (log magnitude plot) of the factor 1/(1 +

*j*ωT) in the transfer function the log magnitude for ω << 1/T can be approximated by

0 dB

20 log ωT dB

-20 log ωT dB

none of the above

⇒ An astable multivibrator circuit using IC 555 timer is shown below. Assume that the circuit is oscillating stea

3 V to 5 V

3 V to 6 V

3.6 V to 6 V

3.6 V to 5 V

⇒ The op-amp used in nonlinear mode is

integrators

active filters

Schmitt triggers

instrumentation amplifiers

⇒ The electric intensity for free space is given by

ε

_{0}

*d*

σ/ε

_{0}

σ.ε

_{0}

*d*/ε

_{0}

⇒ Consider the following

only statement 1 is correct

only statement 2 is correct

both statements are correct

both the statements 1 and 2 are not correct

⇒ In filter system of sideband suppression the advantage of using mechanical filter is

smaller size

good bandpass

good attenuation characteristics

all of the above

⇒ Consider the following statements about a moving iron instrument

- It is an unpolarised instrument.
- It has permanent magnet.
- It has a fixed coil.
- It has two iron vanes.

1, 2, 3 are correct

1, 2, 4 are correct

1, 3 and 4 are correct

2, 3, 4 are correct

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε

_{0}. The surface charge density on the conductor is ((ε

_{0}= 10

^{-9}/36p)F/m)

0 c/m

^{2}

2 c/m

^{2}

1.8 x 10

^{-11}c/m

^{2}

1.14 x 10

^{-9}c/m

^{2}

⇒ The frequency of oscillation in a backward wave oscillator can be changed by

varying the voltage which controls beam velocity

varying the beam current

both by varying the beam current and by light varying the voltage which controls beam velocity

changing the rate of thermionic emission

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will

increase

decrease

remain the same

may increase or decrease

⇒ The carriers of

*n*channel JFET are

free electrons and holes

holes

free electrons or holes

free electrons