Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Three resistances each of R Ω are corrected to form a triangle. The resistance between any two terminals will be |

A. | R Ω [Wrong Answer] |

B. | 3/2 R Ω [Wrong Answer] |

C. | 3 R Ω [Wrong Answer] |

D. | 2/3 R Ω [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :The Histographics show Said on 2022-01-19 20:55:232 in series and that combines to provide 2R 1R in parallel with 2R 1Rx2R/1R+2R so 2R^2/3R= 2/3 R Umapati k Said on 2018-08-15 02:54:51Resistance between any two terminals can be found by. R=2*1/2+1=2/3 !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ For which of the following substances the temperature co-efficient of resistivity is positive ?

Carbon

Germanium

Electrolyte

Aluminium

⇒ A closed switch has a resistance of

zero

about 50 ohms

about 500 ohms

infinity

⇒ A resistance having rating 10 ohms, 10 W is likely to be a

metallic resistor

carbon resistor

wire wound resistor

variable resistor

⇒ The resistance of a parallel circuit consisting of two branches is 12 ohms. 1f the resistance of one branch is 18 ohms, what is the resistance of the other?

18 ω

36 ω

48 ω

64 ω

⇒ The resistance of two wires is 25 ω when connected in series and 6 ω when joined in parallel. The resistance of each wire is

10 ω, 15 ω

20 ω, 30 ω

5 ω, 10 ω

10 ω, 20 ω

⇒ Three parallel resistive branches are connected across a dc supply. What will be the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio R1 : R2 : R3 : : 2 : 4 : 6 ?

3 : 2 : 6

2 : 4 : 6

6 : 3 : 2

6 : 2 : 4

⇒ Voliage dependent resistors are used

for inductive circuits

to supress surges

as heating elements

as current stabilizers

⇒ When the temperature of metallic conductor is increased, its resistance

Always decreases

Always increases

May increase or decrease

Remains the same

⇒ Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be

160 ohms

80 ohms

20 ohms

10 ohms

⇒ A light bulb draws 300 mA when the voltage across it is 240 V. The resistance of the light bulb is

400 ω

600 ω

800 ω

1000 ω

⇒ Which of the following materials possesses the least specific resistance?

Aluminium.

Copper.

Silver.

Iron.

⇒ Which of the following is an ohmic conductor?

Transistors

Thermionic valves

Constanton

Electrolyte

⇒ Four resistances 80 ω, 50 ω, 25 ω and R are connected in parallel. Current through 25 ω resistance is 4 A. Total current of the supply is 10 A. The value of R will be

66.66 ω

40.25 ω

36.36 ω

76.56 ω

⇒ With rise in temperature the resistance of pure metals

increases

decreases

first increases and then decreases

remains constant

⇒ The example of non-ohmic resistance is

Copper wire

Carbon resistance

Diode

Tungsten wire

⇒ The hot resistance of the filament of a bulb is higher than the cold resistance because the temperature coefficient of the filament is

negative.

infinite.

zero.

positive.

⇒ N equal resistances are first connected in series and then connected in parallel. What is the ratio of the maximum to the minimum resistance ?

n

^{ 1 }^{n2}

n

^{2}

^{1}/

_{n}

⇒ How are 500 ω resistors connected so as to give an effective resistance of 750 ω ?

Three resistors of 500 ω each, in parallel

Three resistors of 500 ω each, in series.

Two resistors of 500 ω each, in parallel.

Two resistors of 500 ω each, in parallel and the combination in series with another 500 ω resistor.

⇒ The temperature-coefficient of resistance of conductors is

Positive

Negative

Neutral

First A then C

⇒ With rise in temperature the resistance of semi-conductors

decreases

increases

first increases and then decreases

remains constant

⇒ A rheostat differs from potentiometer in the respect that it

has lower wattage rating

has higher wattage rating

has large number of turns

offers large number of tappings

⇒ Two resistances R1 and R2 are connected in series across the voltage source where R2 > R1. The largest drop will be across

R2

R1

either R1 or R2

none of them

⇒ Four wires of same material, the same cross-sectional area and the same length when connected in parallel give a resistance of 0.25 ω. If the same four wires are connected is series the effective resistance will be

1 ω

2 ω

3 ω

4 ω

⇒ In a circuit containing two unequal resistors connected in parallel

The current is same in both the resistors

The current is larger in larger resistance

The voltage drop is same across both the resistances

The voltage drop is larger across larger resistances

⇒ Heat in a conductor is produced on the passage of electric current due to

reactance

capacitance

impedance

resistance

⇒ In a circuit a 33 ω resistor carries a current of 2 A. The voltage across the resistor is

33V

66V

80 V

132V

⇒ A thermistor has

positive temperature coefficient

negative temperature coefficient

zero temperature coefficient

variable temperature coefficient

⇒ Which of the following statements is correct regarding resistance?

The resistance of a conductor is the hindrance by which the conductor opposes the flow of current through it.

The resistance of wire is independent of the temperature for most of the materials

The resistance of a wire does not depend upon its material.

None of the above.

⇒ Twelve 1 ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is

5/6 ω

1 ω

6/5 ω

3/2 ω

⇒ Which of the following quantities remain the same in all parts of a series circuit?

Voltage

Current

Power

Resistance